3 Tune in to a station you want while “Manual Search” is flashing.
To tune in to stations of higher frequencies
To tune in to stations of lower frequencies
•If you release your finger from the button, the manual mode will automatically turns off after 5 seconds.
•If you hold down the button, the frequency keeps changing (in 200 kHz intervals for FM and 10 kHz for AM) until you release the button.
If the sound quality decreases and the stereo effect is lost while listening to an FM station
In some areas, adjacent stations may interfere with each other. If this interference occurs, this unit can automatically reduce this interference noise (the initial setting when shipped from the factory). However, in this case, the sound quality will be degraded and the stereo effect will also be lost.
If you do not want to degrade the sound quality and to lose the stereo effect, rather than to eliminate the interference noise, see “To change the FM tuner
ENGLISH
When an FM stereo broadcast is hard to receive:
1Press M (MODE) while listening to an FM stereo broadcast.
“Mode” appears on the display. The
2Press number button 1 to select “Mono On” while “Mode” is still on the display.
Each time you press the button, “Mono On” and “Mono Off” appears alternately.
When “Mono On” is selected, the MONO indicator lights up on the display, the sound you hear becomes monaural but the reception will be improved.
Storing stations in memory
You can use one of the following two methods to store broadcasting stations in memory.
•Automatic preset of FM stations: SSM (Strong- station Sequential Memory)
•Manual preset of both FM and AM stations
FM station automatic preset: SSM
You can preset 6 local FM stations in each FM band (FM1, FM2, and FM3).
1 Select the FM band (FM1 – 3) you want to store FM stations into.
Each time you press the button, the band changes as
follows:
FM1 
FM2 
FM3 
AM
CONTINUED ON THE NEXT PAGE
11
