When using the optional stay, Removing the unit

When using the optional stay

Fire wall

Dashboard

Stay (option)

When installing the unit without using the sleeve

In a Toyota for example, first remove the car radio and install the unit in its place.

*2 Not included for this unit.

Flat type screws (M5 x 8 mm)*2

Bracket*2

Screw (option)

Install the unit at an angle of less than 30˚.

Flat type screws (M5 x 8 mm)*2

Pocket

Bracket*2

Note : When installing the unit on the mounting bracket, make sure to use the 8 mm-long screws. If longer screws are used, they could damage the unit.

Removing the unit

Before removing the unit, release the rear section.

Insert the two handles, then pull them as illustrated so that the unit can be removed.

ELECTRICAL CONNECTIONS

To prevent short circuits, we recommend that you disconnect the battery’s negative terminal and make all electrical connections before installing the unit.

•Be sure to ground this unit to the car’s chassis again after installation.

Notes:

•Replace the fuse with one of the specified rating. If the fuse blows frequently, consult your JVC car audio dealer.

•It is recommended to connect to the speakers with maximum power of more than 50 W (both at the rear and at the front, with an impedance of 4 Ω to 8 Ω). If the maximum power is less than 50 W, change “AMP GAIN” setting to prevent the speakers from being damaged (see page 24 of the INSTRUCTIONS).

•To prevent short-circuit, cover the terminals of the UNUSED leads with insulating tape.

•The heat sink becomes very hot after use. Be careful not to touch it when removing this unit.

Heat sink

PRECAUTIONS on power supply and speaker connections:

•DO NOT connect the speaker leads of the power cord to the car battery; otherwise, the unit will be seriously damaged.

•BEFORE connecting the speaker leads of the power cord to the speakers, check the speaker wiring in your car.

TROUBLESHOOTING

•The fuse blows.

*Are the red and black leads connected correctly?

•Power cannot be turned on.

*Is the yellow lead connected?

•No sound from the speakers.

*Is the speaker output lead short-circuited?

•Sound is distorted.

*Is the speaker output lead grounded?

*Are the “–” terminals of L and R speakers grounded in common?

•Noise interfere with sounds.

*Is the rear ground terminal connected to the car’s chassis using shorter and thicker cords?

•Unit becomes hot.