A Typical Connections
Before connecting: Check the wiring in the vehicle carefully. Incorrect connection may cause serious damage to this unit. The leads of the power cord and those of the connector from the car body may be different in color.
1
2
3
Connect the colored leads of the power cord in the order specified in the illustration below.
Connect the antenna cord.
Finally connect the wiring harness to the unit.
Line out (see diagram 
)
Rear ground terminal
LINE IN (see diagram 
)
VIDEO OUT (see diagram 
)
15 A fuse
*1 Not included for this unit.
Antenna terminal
CD changer jack (see diagram 
)
Ignition switch
Black
To metallic body or chassis of the car
Yellow *2
To a live terminal in the fuse block connecting to the car battery (bypassing the ignition switch) (constant 12 V)
Red
To an accessory terminal in the fuse block
Fuse block
Blue
To the automatic antenna if any (250 mA max.)
*2 Before checking the operation of this unit prior to installation, this lead must be connected, otherwise power cannot be turned on.
Blue with white stripe
To the remote lead of other equipment (200 mA max.)
Brown
To cellular phone system
Light green
To parking brake, metallic body or chassis of the car
White with black stripe | White | Gray with black stripe |
| Left speaker (front) | |
Gray | Green with black stripe | Green | Purple with black stripe | Purple |
Right speaker (front) | Left speaker (rear) | Right speaker (rear) | ||
B Connecting the parking brake wire
When installing the monitor in a location where it can be seen by the driver
Connect the parking brake wire to the parking brake system built in the car.
Parking brake wire (light green)
Parking brake
To metallic body or chassis of the car
Parking brake switch (inside the car)
When installing the monitor in a location where it cannot be seen by the driver
Connect the parking brake wire to metallic body or chassis of the car.
Parking brake wire (light green)
C Connecting the crimp connector
Wire connecting the battery and the parking brake switch. | Contact the metallic part of the crimp to the wires inside. |
Attach the parking brake wire to this point.
Pinch the crimp firmly.
3
