To tune to your favorite station
The unit automatically turns on (if it has been off).
Your favorite station is turned in – except when the tape is playing.
•If you press the button again, the last received station will be tuned in.
Tuning into a preset station
You can easily tune into a preset station. Remember that you must store stations first. If you have not stored them yet, see “Storing stations in memory” on page 7.
1 Select the band (FM1 – 3, AM) you want.
F M | FM1 | FM2 |
FM3 |
| |
|
|
A M
AM
2 Select the number (1 – 6) for the preset station you want.
Changing the AM/FM channel intervals
When using this unit in an area other than North or South America:
When this unit is shipped from the factory, the channel intervals are set to 10 kHz for AM and 200 kHz for FM. You can change the channel intervals by following the procedure below.
1 Press SEL (select) for more than 2 seconds. “CLOCK H”, “CLOCK M” or “AREA” appears on the display.
2 If “AREA” does not appear, press 
or 
until it appears.
3 Press +.
“AREA EU” appears and the channel intervals are set to 9 kHz for AM and 50 kHz (for manual tuning) / 100 kHz (for searching) for FM.
To reset to the factory setting, follow the above step 1 and 2, then press – in step 3 (“AREA US” appears on the display.)
AREA EU: Select this when used in an area other than North and South America.
AREA US: Select this when used in North or South America.
ENGLISH
Scanning broadcast stations
When you press SCAN while listening to the radio, station scanning starts. Each time a broadcast is tuned in, scanning stops for about 5 seconds (tuned frequency number flashes on the display), and you can check what program is now being broadcast.
If you want to listen to that program, press the same button again to stop scanning.
9
