Other convenient tuner functions
¢
4 
SEL
RPT MO
Control dial
SCAN Ù
Scanning broadcast stations
When you press SCAN Ù (Scan/Dolby NR) while listening to the radio, station scanning starts. (“SCAN” appears on the display.) Each time a
SCANbroadcast is tuned in, scanning stops for about 5 seconds (tuned frequency number flashes on the display), and you can check what program is now being broadcasted.
If you want to listen to that program, press the same button again to stop scanning.
Selecting FM reception sound
When an FM stereo broadcast is hard to receive:
Press RPT MO (Repeat/Monaural) while listening to an FM stereo broadcast. The sound you hear becomes monaural but reception will be improved.
ENGLISH
RPT
MO
Lights up when receiving an FM broadcast in stereo.
J | ANA |
To restore the stereo effect, press the same button again.
Changing the AM/FM channel intervals
When this unit is shipped from the factory, the channel intervals are set to 10 kHz for AM and 200 kHz for FM (so that the unit can be used in North and South America).
When using this unit in an area other than North and South America, change the channel intervals by following the procedure below.
•AREA EU: Select this when used in an area other than North and South America.
•AREA US: Select this when used in North or South America.
1 Press SEL for more than 2 seconds.
One of the PSM items appears on the display.
2 If “PSM AREA” does not appear, press ¢ 
or 4 
repeatedly until it appears.
3 Turn the control dial to the right.
“AREA EU” appears and the channel intervals are set to 9 kHz for AM and 50 kHz (for manual tuning) / 100 kHz (for searching) for FM.
4 Press SEL again to finish the setting.
To reset to the factory setting, follow the above step 1 and 2, then turn the control dial to the left in step 3 (“AREA US” appears on the display).
11
