28
Preparation:
• Turn ON the TV and set to the video input mode.
Make sure TV/VCR/DVD switch has been slided to VCR/DVD. Then
press VCR to select the VCR mode. (The VCR indicator will light)
1Load a blank cassette tape with the
erase prevention tab intact. (The
DVD/VCR will automatically turn
on.)
2Select the program(e.g.29) you want to record with PR +/– or
number keys.
1~9 : e.g. 5 = press “5
10~80 : e.g. 29 = press “2” and 9”.
3If a recording in Long Play mode is intended, press (TAPE
SPEED) to display "LP". (see Note below)
4On the VCR, press 2.
Or on the Remote, while holding 2,
press .
" " will appear on the screen for
about 4 seconds and “REC” will
appear on the display.
If the erase prevention tab is removed, the tape will eject when
both the 2 and are pressed for recording. (see p.22)

To Stop Recording

Press 3.

To Stop Recording Temporarily

To stop a recording for a short
period of time press 4. Press this
button again if you want to resume
the recording.

Attention:

A safety circuit turns the pause mode off automatically after 5
minutes, and the DVD/VCR will stop the recording mode.
REC
VCR
VCR
REC
VCR

Recording a TV Program

Notes:
Since the DVD/VCR has a built-in TV
tuner the TV set may be turned off when
recording. The TV set may only be used
to check for accurate program adjust-
ments or to monitor recordings.
You can confirm on the TV-screen whether
you selected SP or LP. Press OSD to see the
status display. (see page 29)
If you wish to watch the DVD playback
during the normal recording on VCR,
press DVD to change to DVD mode and
perform the DVD playback (see page
42).
VCR
VCR
2A73501AE(28-33) 4/17/02, 8:25 PM28