JVC LPT0923-001B manual Installing Satellite Controller

		SAT CONTROL SET EN 23
Satellite Receiver Control Setting		The following procedure is required if you receive satellite channels
		through a satellite receiver. Approximately 20 seconds before the
		SHOWVIEW timer programming ( pg. 44) or Manual Timer
	Satellite receiver	programming ( pg. 46) starts, the unit sets its input mode to “L-2”
		and automatically switches the satellite receiver’s channels using
		the provided Satellite Controller.

Satellite Controller

Your unit(provided) (suggested locations)

Transmitter Satellite Controller

(provided)

Installing Satellite Controller

1 Place the Satellite Controller so that the path between its transmitter and the satellite receiver’s remote sensor is unobstructed.

2Fix securely using the adhesive strip attached on the back of the Satellite Controller.

3Be sure to connect the unit’s L-2 IN/DECODER connector to the satellite receiver’s 21-pin SCART connector.

NOTE:

When connecting your satellite receiver, refer to its instruction manual.

4 Connect the Satellite Controller to the SAT CONTROL connector on the rear panel.

Satellite receiver

21-pin SCART cable (provided)

Back of unit

L-2 IN/DECODER SAT CONTROL

CABLE/SAT

TV DVD

Setting Satellite Receiver’s Brand And Channel

After installation, set the satellite receiver’s brand and channel correctly; otherwise, the Satellite Controller cannot work correctly.

●Turn on the unit.

●Turn on the TV and select the AV mode.

●Slide the TV/CABLE/SAT/DVD switch to DVD.

1Turn on the satellite receiver’s power.

2Press SET UP to access the Main Menu screen.

3Press w e to select “INITIAL SET UP”, then press t.

4Press w e to select “TUNER

SET”, then press t.	DVD VIDEO SET UP HDD/DVD SET UP FUNCTION SET UP			INITIAL SET UP
	TUNER SET	CLOCK SET
5 Press rt w e to select “SAT		AUTO CH SET	MANUAL CH SET
CONTROL SET”, then press
ENTER.		SAT CONTROL SET	GUIDE PROG SET
6 Press rt to select “BRAND”,			11 12 13
then press ENTER.	SET UP	ENTER SELECT WITH [	] THEN PRESS [ENTER]
		PRESS [SET UP] TO EXIT

EXIT SELECT

7 Press rt to select the brand

code from the list on page 24, then press ENTER.

●If the unit is in playback or recording mode, you cannot set the brand code.

8Press rt to select “PROGRAMME”, then press ENTER.

9Press rt to select one of the channel positions on the satellite receiver, then press ENTER.

● You can select the channel position between 1 to 999.

ENTER

rtwe

10 Press rt to select “TEST”, then press ENTER. The unit enters the Test mode.

INITIAL SET UP > SAT CONTROL SET

BRAND	73
PROGRAMME	12
	TEST

SET UP	ENTER	SELECT WITH [	] THEN PRESS [ENTER]
		PRESS [SET UP] TO EXIT

EXIT SELECT

SET UP