JVC LYT0002-0P7A No power is supplied, Doesn’t come back on by itself, Recording does not start

42EN

TROUBLESHOOTING

SYMPTOM	POSSIBLE CAUSE(S)
POWER
No power is supplied.	● The battery pack has not been attached correctly
	(☞ pg. 4).
	● The battery pack is not charged (☞ pg. 4).
	● The power supply has not been correctly connected
	(☞ pg. 5).
The power suddenly goes off and	● The battery pack has completely discharged.
doesn’t come back on by itself.	● Remove the cassette and disconnect the power source,
	then after a few minutes, try turning the power back on. If
	it still doesn’t come on, consult your nearest JVC dealer.
RECORDING
Recording cannot be performed.	● The recording tape’s Erase Protection tab is missing.
	Cover the hole with adhesive tape. (Some tapes have
	sliding tabs. In this case, check the position of the tab.)
Recording does not start.	● The camcorder Power switch has not been set to
	“CAMERA” (☞ pg. 11).
PLAYBACK
The tape is running, but there’s no	● The TV has not been set to its VIDEO mode.
playback picture.	● If A/V connection is used, the TV’s VIDEO/TV switch has
	not been set to VIDEO.
	● The RF unit has not been set to the correct channel.
Noise bars appear in the playback	● Manual Tracking has not been performed (☞ pg. 31).
picture.
Noise appears throughout the entire	● This occurs when playing back a blank portion of tape.
playback picture.	● If this occurs when playing a recorded portion, there is a
	possibility that the video heads are dirty or the camcorder
	is broken. Consult your nearest JVC dealer.
Playback picture is blurred or	● The video heads are dirty or worn out. Consult your
interrupted.	nearest JVC dealer for head cleaning or replacement.
The counter indication is blurred	● This is normal.
during Still playback.
Tape was played back on VCR using	● Tapes recorded in S-VHS cannot be played back on
cassette adapter but picture could	regular VHS VCRs (☞ pg. 8).
not be viewed.	Connect camcorder directly either to VCR or to TV, then
	playback can be performed on camcorder (☞ pg. 28).
TAPE TRANSPORT
The tape stops during fast-forward or	● The Counter Memory Function has been activated
rewind.	(☞ pg. 31).
Rewinding or fast-forwarding cannot	● The tape is already fully wound on one reel or the other.
be performed.