EN 71
SYMPTOM | POSSIBLE CAUSES | CORRECTIVE ACTION |
35. The LCD monitor | 35. •Certain FADE/WIPE, P.AE/ |
indications blink. | Effects, DIS and other |
| functions that cannot be |
| used together are selected at |
| the same time. |
35.
Effects and DIS
(☞ pgs. 32, 36 – 43).
36. Coloured bright spots | 36. •The LCD monitor is made | 36. |
appear all over the LCD | with |
|
monitor. | technology. However, black |
|
| spots or bright spots of light |
|
| (red, green or blue) may |
|
| appear constantly on the | |
| LCD monitor. These spots |
|
| are not recorded on the |
|
| tape. This is not due to any |
|
| defect of the unit. (Effective |
|
| dots: more than 99.99 %) |
|
37. The LCD monitor | 37. •During playback of the | 37. |
indications are distorted. | unrecorded portion, High- |
|
| speed Search and still | |
| playback, LCD monitor | |
|
| |
| indications appear distorted. |
|
| This is not a defect. |
|
38. An unusual mark appears | 38. | 38. •Check the section of the |
in the LCD monitor or the |
| manual that explains LCD |
viewfinder. | monitor/viewfinder | |
|
| indications (☞ pgs. 73 – |
|
| 78). |
39. An error indication | 39. •A malfunction of some kind | 39. •Remove the power supply |
(E01 — E07) appears in | has occurred. In this case | (battery pack, etc.) and |
the LCD monitor or the | the camcorder’s functions | press RESET button, and |
viewfinder. | become unusable. | wait a few minutes for the |
|
| indication to clear. When it |
|
| does, you can resume using |
|
| the camcorder. |
|
| If the indication remains, |
|
| please consult your nearest |
|
| JVC dealer. |
40. The charge indicator on | 40. •The temperature of the | 40. •To protect the battery, it is |
the AC Power Adapter/ | battery is extremely high/ | recommended to charge it |
Charger does not light. | low. | in places with a tempera- |
| •Charging is difficult in | ture of 10°C to 35°C |
| places subject to extremely | (☞ pg. 9). |
| high/low temperatures. |
|
41. The recording mode | 41. •This occurs when recording in | 41. |
indicator “LP” blinks on | the LP mode is not available. |
|
the LCD monitor or the | After the indicator blinks, the | |
viewfinder. | recording mode switches to |
|
| “SP” and recording goes on. |
|
42. Picture does not appear | 42. •The viewfinder is pulled out. | 42. •Push the viewfinder back in. |
on the LCD monitor | •The LCD monitor's | •Adjust the brightness of the |
| brightness setting is too | LCD monitor (☞ pg. 22). |
| dark. | •If the monitor is tilted |
|
| upward 180 degrees, open |
the monitor fully (☞ pg. 23).
