EN
9
Charging Environment
Perform charging where the temperature is between 10° and 30°C. 20° to 25°C is the ideal temperature range for charging. If the environment is too cold, charging may be incomplete.
Continuous Shooting
Continuous shooting is possible (See table below for recording time) under the following conditions:
•The temperature is approximately 20°C
However, . . .
•If the temperature is below 10°C, or
•If zoom or
No. of batteries to supply power |
| Approximate recording | |
| time (unit: min) | ||
|
|
| |
|
|
|
|
Using one battery |
| 60 | |
|
|
| |
Using one battery | 120 | ||
|
| ||
|
|
|
|
Using two batteries; one |
| 120 | |
camcorder and one |
|
|
|
installed in the optional Battery Holder |
| 180 | |
attached to the camcorder |
| ||
|
| ||
|
|
| |
|
|
|
|
Using a |
| 420 | |
|
|
|
|
*The
Installing The Battery Pack
The battery pack has not been charged at the factory. Before installing it in the camcorder, be sure to charge it with the AC Charger Station (☞ pg. 8). It is also possible to charge the battery pack installed in the camcorder (☞ pg. 53).
Open switch (BATTERY)
Battery cover
Battery
OPEN BATTERY COVER | |
1 Slide down the open switch. | |
INSERT CHARGED BATTERY | |
2 Insert the | mark end of the battery first. |
Inserting the battery backwards will result in malfunction.
3 CLOSE BATTERY COVER
NOTES:
●To remove the battery pack, turn off the camcorder and open the battery cover so that the battery pack comes out halfway. Then pull out the battery pack.
●Be careful not to drop the battery pack.
