JVC Model HR-VP639U manual On-Screen Timer Programming, Access Program SET Screen

40TIMERRECORDING(cont.)

On-Screen

Timer

Programming

MENU

6

q

	CH
	1	2	3
NUMBER	4	5	6
	7	8	9
		0

CH

OK

MENU

SHUTTLE PLUS

ILLUMI GUIDE

When Using The Illumi-Guide Feature

● Buttons light or blink on the remote control for approximately 10 seconds. If the button or buttons extinguish during timer programming, press ILLUMI GUIDE and the button or buttons previously lit or blinking come back on. If the button or buttons do not re-light or start blinking again, press MENU as many times as necessary to return to the normal screen and extinguish all illuminated buttons, and re-perform the timer programming procedure from the beginning.

● If for some reason the remote control's signal is not received by the VCR, press MENU as many times as necessary to return to the normal screen and extinguish all illuminated buttons, and re-perform the timer programming procedure from the beginning.

You can directly program the VCR’s timer to record up to 8 shows, as far as a year in advance. Remember, the clock must be set before you can program the timer (☞ pg. 7 or 9).

Or you can use the Illumi-Guide feature, where the remote control tells you which button to press next by lighting it up. To use the Illumi-Guide feature, with the TV/CABLE/VCR switch set to "VCR", press ILLUMI GUIDE before performing step 2. (MENU, REW, PLAY, FF light up at this time.)

If you aren't going to use the Illumi-Guide feature, go directly to step 1.

LOAD A CASSETTE

1 Make sure the record safety tab is intact. If not, cover the hole with adhesive tape, then load.

●The VCR comes on, and the counter is reset, automatically.

●If watching channel 3 or 4, press TV/VIDEO to select the VIDEO mode. VIDEO is displayed on the front display panel.

	ACCESS ON-SCREEN
2	MENU
	Press MENU as many times as necessary to bring up the
	Main Menu screen.
	● If you are using the Illumi-Guide feature, MENU
	lights up and OK blinks.

ACCESS PROGRAM SET SCREEN

	Make sure the arrow is to	PROGRAM 1
	the left of "PROGRAM
3 SET", then press OK.		DATE	- - / - -
		START	- - : - - AM
	● If you are using the	STOP	- - : - - AM
		CHANNEL	- - SP
	Illumi-Guide feature, OK	PRESS NUMBER KEY(0-9)
	blinks when the
		OR (5,°), THEN (OK)
	following buttons are lit:	PRESS (MENU) TO END
	NUMBER keys (0 – 9),
	SHUTTLE PLUS, CANCEL and MENU.
	SELECT PROGRAM
	NUMBER
	Press the appropriate NUMBER keys or CH5°or
	SHUTTLE PLUS 5°to select a vacant program number,
4 then press OK. The first time you do this, all numbers will
	be vacant, so just press OK when the screen appears.

●If you are using the Illumi-Guide feature, OK blinks when the following buttons are lit: NUMBER keys (0

– 9), SHUTTLE PLUS, CANCEL and MENU.