JVC MX-D602T Reinforcing the Bass Sound, For private listening, Press S.A. BASS, Display at the

SHIFT

L BALANCE R

CAUTION: The Volume cannot be adjusted while the Unit is on STANDBY. DO NOT turn on the Unit and/or start playing any source without setting the VOLUME control to 0; otherwise, the sudden blast of sound can damage your hearing, speakers and/or headphones.

For private listening

Connect a pair of headphones to the PHONES jack. No sound comes out of the speakers. Be sure to turn down the volume before connecting or putting on headphones.

Balance Adjustment ————————————————————

You can use the Remote Control to adjust the left and right balance of the speakers.

1.Press SHIFT.

2.Press BALANCE L (10) or R (+10).

The display changes to show the balance adjustment.

Pressing L (10) moves the pointer to the left, pressing R (+10) moves the pointer to the right.

Display when set for no	Display at the	Display when set for no
sound from the right speaker.	center position.	sound from the left speaker.

The balance is normally set to the center position.

Note: If no adjustments are made for 2 seconds in balance adjustment mode, the display reverts to the previous display.

Reinforcing the Bass Sound

S.A. (Signal Adaptive) BASS adjusts low tones at low volume to enhance their effect. When the volume level is low, this enhances low tones that are normally difficult to hear and adjusts low tones to a fixed level to reduce low tone distortion.

Press S.A. BASS.

S.A.BASS

or

Pressing S.A. (Signal Adaptive) BASS changes the bass setting in the following order.

=SA-BASS1= SA-BASS2=OFF =(back to the beginning)

The S.A. BASS indicator lights up, and “SA-BASS1” or “SA-BASS2” appears on the display for three seconds.

SA-BASS2 enhances low tones more than SA-BASS1.

To cancel the effect, press S.A. BASS until “OFF” appears on the display. The button light goes out.

To recall the previous S.A. BASS mode, press S.A. BASS once.

When listening to recording with low volume low tones, the difference between SA-BASS1 and SA- BASS2 is clear. When listening to recording with louder low tones, however, the difference between SA-BASS1 and SA-BASS2 may not be so clear.

10