JVC MX-GB5C Using Recording Timer, Select the preset station number, On the unit ONLY, English

6 Select the preset station number.

Press ¢ or 4 to select the preset station number, then press

SET/DISPLAY.

The unit enters volume setting mode.

7 Press ¢or 4to set the volume level.

•You can select the volume level from VOL MIN, VOL 1 — VOL 30, and VOL MAX.

WOOFER

8 Press SET/DISPLAY to complete the Daily Timer setting.

The DAILY (daily timer) indicator stops

flashing and remains lit. The settings you have done are shown on the display in sequence for your confirmation.

9 Press STANDBY/ON to turn off the unit (on standby) if you have set the Daily Timer with the unit turned on.

If the unit is turned on when the timer-on time comes

Daily Timer does not work.

To turn on or off Daily Timer after its setting is done

1 Press CLOCK/TIMER repeatedly until “DAILY” appears on the display.

2 To turn off the Daily Timer, press

CANCEL/DEMO.

The DAILY (daily timer) indicator goes off from the display (“OFF” appears for a while).

The Daily Timer is canceled, but the setting for the Daily Timer remains in memory until you change it.

To turn on the Daily Timer, press

SET/DISPLAY.

The DAILY (daily timer) indicator lights up on the display. The settings you have done are shown on the display in sequence for your confirmation.

Continued

Using Recording Timer

With Recording Timer, you can make a tape of a radio broadcast automatically. You can set the timer whether the unit is on or off.

How Recording Timer actually works

The unit automatically turns on, tunes in to the specified station, sets the volume level to “VOL MIN,” and starts recording when the on-time comes (the indicator flashes while the timer is operating). Then, when the off-time comes, the unit automatically turns off (stands by).

Recording Timer works only once, but the timer setting remains in memory until you change it.

•There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 2 again.

•If you have made a mistake while setting the timer, press CANCEL/DEMO. (However, this does not always work. If CANCEL/DEMO does not work, press CLOCK/TIMER repeatedly and start from step 2 again.)

Before you start...

Make sure to preset a station you want to record. (See

page 12.)

On the unit ONLY:

1 Put a recordable cassette into deck B.

2 Press CLOCK/TIMER repeatedly until “REC” appears on the display.

indicator lights up and the REC (recording timer) indicator starts flashing on the display.

WOOFER

•Each time you press the button, the clock/timer setting modes change as follows:

DAILY ON TIME REC

(Daily Timer)

Canceled CLOCK ON TIME

(See page 9.) (Recording Timer)

3 Press CLOCK/TIMER again.

“ON TIME” appears for 2 seconds, then the unit enters on-time setting mode.

WOOFER

English

24