Listening to FM and AM Broadcasts
English
Tuning in a Station
On the unit ONLY :
1 Press FM/AM u.
2
3
Press SET k.
Press PRESET – / + ; to select a preset number.
SET
PRESET
PREV NEXT
The unit automatically turns on and tunes in the previously tuned station (either FM or AM). The Powered Rolling Panel automatically opens.
•Each time you press the button, the band alternates between FM and AM.
2 Press and hold TUNING
FM/ AM
TUNING
4
Press SET k again.
SET
The unit starts searching for stations and stops when a station of sufficient signal strength is tuned in.
If a program is broadcast in stereo, the ST indicator lights up.
To stop during searching, press TUNING
The tuned station in step 1 is stored in the preset number selected in step 3.
•Storing a new station on a used number erases the previously stored one.
When you press TUNING
The frequency changes step by step.
To change the FM reception mode
When an FM stereo broadcast is hard to receive or noisy, FM MODE press FM MODE & on the remote control so that the MONO indicator lights up on the display. Reception improves.
To restore the stereo effect, press FM MODE & again so that the MONO indicator goes off.
When you unplug the AC power cord or if a power failure occurs
The preset stations will be erased in a few days. If this happens, preset the stations again.
Tuning in a Preset Station
1 Press FM/AM u, +.
The unit automatically turns on and tunes in the
In this stereo mode, you can hear stereo sounds when a program is broadcast in stereo.
previously tuned station (either FM or AM). The Powered Rolling Panel automatically opens.
FM/ AM
•Each time you press the button, the band alternates between FM and AM.
Presetting Stations
You can preset 30 FM and 15 AM stations.
In some cases, test frequencies have been already memorized for the tuner since the factory examined the tuner preset function before shipment. This is not a malfunction. You can preset the stations you want into memory by following the presetting method.
•There is a time limit in doing the following steps. If the setting is cancelled before you finish, start from step 1 again.
1 Tune in the station you want to preset.
• See “Tuning in a Station” above.
MHz
2 Select a preset number. On the unit:
Press PRESET
On the remote control:
Press the number buttons ^. For preset number 5, press 5.
For preset number 15, press +10, then 5. For preset number 20, press +10, then 10. For preset number 25, press +10, +10, then 5.
PRESET
PREV NEXT
16
16 |
|
| 6/30/99, 2:26 PM | |
|
|
|
|
|