Presetting the desired stations (using the remote control unit)

30 stations in the FM band and 15 stations in the AM (MW/LW) band can be preset as follows:

÷Example: (Presetting an FM station broadcasting at 103.5 MHz to preset button “15”)

SLEEP

DOWN UP SET

 

 

 

PROGRAM

 

 

 

RANDOM

4

 

 

AUTO

REPEAT

 

 

 

PRESET

 

AUX

C D

TAPE

TUNER

1

BAND

 

 

 

FM MODE

2

REVERSE MODE

REW

MULTI CONTROL

FF

DISPLAY

 

 

 

3

SOUND ACS

1Press the TUNER BAND/FM MODE button.

2Select the FM band using the TUNER BAND/FM MODE button.

3Tune to the required station.

4Press preset button “+10”, then “5” for more than 2 sec.

(When “15” blinks in the preset station display, the station has been stored.)

÷Repeat the previous procedure for each of the other stations, using a different preset button each time.

÷Repeat the previous procedure for the other band.

÷To change preset stations

Perform step 4 after tuning to the required station.

Notes:

÷The previously stored station is erased when a new station is stored, because the new station’s frequency replaces the previous frequency in memory.

÷When listening to an AM (MW/LW) broadcast, noise may be heard if the remote control unit is used.

To prevent the preset stations from being erased because of a power failure, etc., install memory back-up batteries in the unit (see page 6).

MHz

Preset station tuning (Receiving the preset stations)

÷The stations must be preset before this operation can be performed.

(Using the main unit)

1Press the TUNER BAND button.

2Select the band using the TUNER BAND button.

3Each time the PRESET TUNING button is pressed, the next preset station is selected.

(Using the remote control unit)

1Press the TUNER BAND/FM MODE button.

2Select the band using the TUNER BAND/FM MODE button.

3Press the required preset station buttons (No. 1 – No. 10 and +10). ÷ The preset station number and frequency corresponding to the button

pressed are shown.

Using the antennas

FM

FM:Adjust the telescopic antenna’s length, angle and direction until optimum reception is received.

AM (MW/LW): Install the unit where suitable reception is possible (beside a window, etc.) or change the direction of the unit.

Note:

The built-in ferrite core antenna can pick up interference from television receivers in the neighborhood and thereby disturb AM (MW/LW) reception.

AM (MW/LW)

19