FEATURES

÷Active Hyper-Bass (AHB) Pro circuit for low-frequency sound reproduction

÷Active Clear Sound (ACS) circuit for enhanced sound reproduction

÷Speaker illumination

÷Sound mode control

÷One-touch operation (COMPU PLAY)

÷34-key remote control unit operates all CD, cassette deck and tuner functions

÷Skip Play/Search Play/Repeat Play/Random Play

÷Programmed play of up to 20 tracks

÷Full-logic cassette mechanism

÷Auto reverse

÷Auto tape select mechanism

÷Metal (type IV) and CrO2 (type II) tape can be played back for superior tone quality

÷CrO2 (type II) tape recording capability

÷2-band digital synthesizer tuner with 45-station (30 FM and 15 AM (MW/ LW)) preset capability

÷Seek/manual tuning

÷Auto preset tuning

÷Timer/Clock function

÷Timer on/off with preset volume function

÷Sleep timer can be set for up to 120 minutes

÷Shoulder strap

÷DC IN 12 V jack for car battery

SAFETY PRECAUTIONS

Prevention of Electric Shocks, Fire Hazards and Damage

1.Even when the button is set to STANDBY, a very small current will flow. To save power and for safety when not using the unit for an extended period of time, disconnect the power cord from the household AC outlet.

2.Do not handle the power cord with wet hands.

3.When unplugging from the wall outlet, always grasp and pull the plug, not the power cord.

4.Consult your nearest dealer when damage, disconnection, or contact failure affects the cord.

5.Do not bend the cord severely, or pull or twist it.

6.Do not modify the power cord in any manner.

7.To avoid accidents, do not remove screws to disassemble the unit and do not touch anything inside the unit.

8.Unplug the power cord when there is a possibility of lightning.

9.If water gets inside the unit, unplug the power cord from the outlet and consult your dealer.

10.Do not block the unit’s ventilation holes that allow heat to escape. Do not install the unit in a badly ventilated place.

button

When the power cord is connected to a household AC wall outlet, the power indicator lights in red indicating the STANDBY mode (only

when AC power is used). When the button is pressed, the power indicator goes out and the display window lights (when using DC power, it lights for only 5 seconds).

When this unit is plugged into an AC wall outlet, it consumes a small current to operate the remote control and timer, or to back up the

memory of the microprocessor, even when the button is set to

STANDBY.

Caution:

Proper Ventilation

To avoid risk of electric shock and fire, and to prevent damage, locate the apparatus as follows:

1. Front:

No obstructions and open spacing.

2. Sides/Top/Back:

No obstructions should be placed in the areas shown by the dimensions below.

3. Bottom:

Place on a level surface. Maintain an adequate air path for ventilation by placing on a table with a height of 10 cm or more.

Front view

 

Side view

15 cm

 

15 cm

15 cm

15 cm

15 cm

ACTIVE

HYPER-BASS

RV-B550

RV-B550

10 cm

10 cm

 

4