Timer recording of broadcast

÷The current time must be set before the timer can be used.

÷Make sure that the safety tabs of the cassette have not been broken off.

Operations

1

5

2

4

ON/STANDBY

SPEAKER

 

 

 

VOLUME

ILLUMINATION

 

 

BAND

AHB PRO

/ACS

SOUND

 

 

 

 

 

C D

TAPE

TUNER

 

PRESET

ONE TOUCH

 

 

 

AUX

TUNING

REC

MULTI CONTROL

 

BEAT CUT

STANDBY AHB PRO

ACS

STOP

FF

 

 

REW

OPEN

3

 

TIMER

CLOCK

TIMER ON/OFF

 

 

 

SLEEP

DOWN

UP

SET

 

 

 

 

PROGRAM

 

 

RANDOM

 

 

AUTO

REPEAT

 

 

PRESET

AUX

C D

TAPE

TUNER

BAND

 

 

 

FM MODE

REVERSE MODE

REW

MULTI CONTROL

FF

1Set the button to ON.

2Load a cassette.

÷Insert the cassette with the side to be recorded facing out.

÷Select the required reverse mode ( or ).

÷Set the tape direction to 3 (forward) by pressing the TAPE 23 button.

3Set the timer. (Refer to “Setting the timer” on page 23.)

÷Set the timer about a minute before the broadcast to be recorded is scheduled to start.

4Tune to the station to be recorded. (Refer to page 18.)

5Set the button to standby.

÷Confirm that the timer mode indicator (REC ) is displayed in the display window.

÷Timer recording will start at timer start time and the power will be switched off at timer stop time. (The timer mode is then released.)

÷To repeat timer recording every day

Press the TIMER ON/OFF button to display the timer mode indicator (REC ) in the display window.

÷To cancel timer operation

Press the TIMER ON/OFF button so that the timer mode indicator

(REC ) goes out.

If you do this, timer recording will not start at the timer start time.

Notes:

Once the timer has been set, the start and stop times, etc., are stored in memory. When timer recording or playback is required at different times, the timer must be set again.

÷After setting the timer start and stop times, check that the tuner is tuned to the required frequency.

÷If memory back-up batteries are exhausted or not installed, and the power cord is disconnected or there is a power failure, timer settings will be erased from memory. If this happens, set the current time and perform the timer setting again.

24