JVC RV-B550BU, RV-B550RD Notes:, Operations, Timer playback, ÷Checking the sleep time, To cancel timer operation, ÷To cancel timer operation, ÷To cancel the sleep timer operation

Timer playback

÷Timer playback of tapes, broadcasts and CDs is possible.

Operations

1	3							2
									TIMER
							CLOCK	TIMER	ON/OFF
	ON/STANDBY	SPEAKER					VOLUME
	ILLUMINATION					BAND
	AHB PRO	/ACS	SOUND			BAND
				C D	TAPE	TUNER			SLEEP
				C D	TAPE	TUNER
		PRESET	ONE TOUCH				DOWN	UP	SET
	AUX	TUNING	REC	MULTI CONTROL			DOWN	UP	SET
	AUX	TUNING	REC	MULTI CONTROL
									PROGRAM
		BEAT CUT	STANDBY AHB PRO	ACS	STOP	FF
		BEAT CUT		REW	STOP	FF

1Set the button to ON.

2Set the timer. (Refer to “Setting the timer” on page 23.)

Source sound	Timer mode	Operations

CD play	CD	Load a disc.

Tape playback	TAPE	Load a cassette tape.

Broadcast	TUNER	Tune to the required station.

3Set the button to STANDBY.

÷Timer playback will start at the timer start time and the power will be switched off at the timer stop time.

The unit remains in the same timer mode even after the power is switched off. The same timer function will repeat at the same time on the following day.

÷When the timer mode is activated, the “” indicator blinks.

÷When the power is switched on, the sound is faded up from volume level 0 (zero) to the preset volume.

÷To cancel timer operation

Press the TIMER ON/OFF button so that the timer mode indicator () goes out.

Notes:

÷When the volume setting is set to “VOL -” (volume level is not specified), the timer playback volume is at the level used before setting the timer. (In this case, the fade-in mode does not function.)

÷To stop during timer playback, press the button to switch the unit off.

Sleep timer operations (using the remote control unit)

A. Use this when you want to fall asleep while listening to a tape, broadcast or CD.

1Set to the required source and tune in a broadcast or play back a CD or tape.

2Press the SLEEP button to set the sleep time.

SLEEP

SLEEP is shown in the display.

Source mode display (Releasing the sleep mode)

÷Sleep time settings of 30, 60, 90 or 120 minutes can be set. When you release the SLEEP button, the source is displayed after 5 sec.

÷The sleep timer operation will start and the power will be switched off after the specified time.

÷Checking the sleep time

When the SLEEP button is pressed, the remaining sleep time is displayed. If it is pressed again, a new sleep time can be set.

÷To cancel the sleep timer operation

Press the button to switch the power off or press the SLEEP button until the sleep time indicator disappears.

B. To fall asleep while listening to a tape, broadcast or CD and to perform timer playback the following morning

1Set the timer. (Refer to “Setting the timer” on page 23.)

2Set to the required source (tape, broadcast or CD).

3Press the SLEEP button to set the sleep time.

SLEEP

Source mode display (Releasing the sleep mode)

÷Any source can be selected for sleep timer operation and timer playback. For example;

•CD play for sleep timer operation and broadcast reception for timer playback.

•Tuner play for sleep timer operation and CD play for timer playback.

However, when broadcast reception is selected for both sleep timer operation and timer playback, the station you heard at night will be tuned to the following morning.