JVC RV-B99 BK/BU Timer recording of broadcast, Operations, ÖTo repeat timer recording every day

Timer recording of broadcast

ÖThe current time must be set before the timer can be used.

ÖMake sure that the safety tabs of the cassette have not been broken off.

Operations

1	5	2	4	3
					TIMER
			CLOCK	TIMER	ON/OFF
						SLEEP
			DOWN	UP	SET
						PROGRAM
						RANDOM
					AUTO	REPEAT
					PRESET

1Set the button to ON.

2Load a cassette.

ÖInsert the cassette with the side to be recorded facing out.

ÖSelect the required reverse mode ( or ).

ÖSet the tape direction to 3 (forward) by pressing the TAPE 23 button.

3Set the timer. (Refer to “Setting the timer” on page 22.)

ÖSet the timer about a minute before the broadcast to be recorded is scheduled to start.

4Tune to the station to be recorded. (Refer to page 18.)

5Set the button to standby.

ÖConfirm that the timer mode indicator (REC ) is displayed in the display window.

ÖTimer recording will start at timer start time and the power will be switched off at timer stop time. (The timer mode is then released.)

ÖTo repeat timer recording every day

Press the TIMER ON/OFF button to display the timer mode indicator in the display window.

ÖTo cancel timer operation

Press the TIMER ON/OFF button so that the timer mode indicator (REC

) goes out.

If you do this, timer recording will not start at the timer start time.

Notes:

Once the timer has been set, the start and stop times, etc., are stored in memory. When timer recording or playback is required at different times, the timer must be set again.

ÖAfter setting the timer start and stop times, check that the tuner is tuned to the required frequency.

ÖIf memory back-up batteries are exhausted or not installed, and the power cord is disconnected or there is a power failure, timer settings will be erased from memory. If this happens, set the current time and perform the timer setting again.

24