POWER SUPPLY
A. Operation on house hold AC
ÖConnect the AC power cord after all other connections have been made.
~AC IN
Power cord
CAUTIONS:
1.ONLY USE WITH JVC POWER CORD PROVIDED WITH THIS UNIT TO AVOID MALFUNCTION OR DAMAGE TO THE UNIT.
2.BE SURE TO UNPLUG THE POWER CORD FROM THE OUTLET WHEN GOING OUT OR WHEN THE UNIT IS NOT IN USE FOR AN EXTENDED PERIOD OF TIME.
B. Batteries for memory
It is recommended that batteries are loaded to prevent the preset station memory and timer, etc. from being erased when there is a power failure, or when the AC power cord is disconnected.
ÖLoading batteries
Load three "R6/AA (15F)" size batteries (optional) into the battery compartment.
ÖOpen the battery cover by pulling it toward you while pressing the sections marked with arrows.
Battery compartment cover
ÖInsert batteries with áend first in the order shown.
2
"R6/AA (15F)" size batteries
3
1
ÖWhen removing the batteries, remove battery number 3 first.
Notes:
ÖThe three "R6/AA (15F)" size batteries supply the power to the memory
(When the memory backup function is activated, the time is not displayed to reduce the power consumption.)
ÖWhen the power cord is not connected or the "R20/D (13F)" size batteries are not loaded, the batteries should be replaced with new ones approximately every 12 months.
(Connect the power cord when replacing batteries in order to backup the memory.)
C. Operation on batteries
ÖLoading batteries
1.Open the battery cover by pulling it toward you while pressing the sections marked by the arrows.
2.Insert 10 “R20/D (13F)” size batteries as shown in the diagram.
*Be careful to insert the batteries with the » and á terminals positioned correctly.
3.Replace the cover.
| 4 |
|
|
9 | 5 |
|
|
|
| 3 |
|
| 10 |
| 2 |
| 8 |
| |
|
| 7 | 1 |
|
|
| |
"R20/D (13F)" size batteries |
| 6 | |
Battery replacement
When the batteries are nearly exhausted, the following symptoms may appear. In this case, replace the batteries with the fresh ones. (Do not use fresh ones and old ones together.)
For the main unit
Mistracking occurs during CD playback (or sound is distorted intermittently during TAPE playback). When these symptoms occur, “DC OFF” appears in the display window and the power is turned off after 1 minute.
For the memory back-up
When the AC power cord is unplugged, the stored memory (timer/clock setting/preset tuning) is erased.
It is recommended that the AC power cord be used when recording important material or listening to a CD.
ÖFor better battery usage
Continuous operation of the unit causes the battery power to be consumed quicker than noncontinuous operation.
Operation of the unit in a cold place causes the battery power to be consumed more quickly than in a warm place.
ÖFor power supply
The use of household AC is recommended, when continuous operation of the unit is required over a longer period of time.
CAUTIONS:
ÖWHEN NOT USING THE UNIT FOR A LONG TIME (MORE THAN TWO WEEKS) OR WHEN ALWAYS USING HOUSEHOLD AC, REMOVE THE BATTERIES TO AVOID A MALFUNCTION OR DAMAGE TO THE UNIT.
ÖWHEN THE JVC POWER CORD PROVIDED WITH THIS UNIT IS CONNECTED, THE POWER IS AUTOMATICALLY SWITCHED FROM THE BATTERIES TO THE HOUSEHOLD AC EVEN WHEN THE BATTERIES ARE LOADED. HOWEVER, REMOVE THE BATTERIES WHEN USING THE POWER CORD.
CAUTIONS WHEN USING BATTERIES
When batteries are used incorrectly, it may result in the leakage of chemicals from the batteries or they may explode. The following care should be taken:
ÖCheck that the positive » and negative á terminals of the batteries are positioned correctly and load them as shown in the diagram.
ÖDo not mix new and old batteries together, or mix different types of batteries.
ÖDo not try to recharge
ÖRemove the batteries when the unit is not to be used for an extended period of time.
If chemicals from the batteries come in contact with your skin, wash them off immediately with water. If chemicals leak onto the unit, clean the unit completely.
6
