JVC RV-B99 BK/BU manual Volume, Sound Mode And Other Controls, Active Clear Sound ACS

VOLUME, SOUND MODE AND OTHER CONTROLS

VOLUME control

+: Use to increase the volume.

– : Use to decrease the volume. (Control range from VOL 0 to VOL 50.)

Ö The volume level is displayed in the display window for 2 seconds.

Main unit	Remote control unit
	VOLUME

VOLUME

SUPER WOOFER VOLUME control

+: Use to emphasize the bass sound.

– : Use to tone down the bass sound. (Control range from BASS 1 to BASS 6.)

Ö The volume level is displayed in the display window for 2 seconds.

Main unit Remote control unit

SUPER WOOFER

VOLUME

SUPER WOOFER

VOLUME

Note:

Because it is rotary, the VOLUME control knob and the SUPER WOOFER VOLUME control knob do not have a volume stopper. Check the volume level in the display window when adjusting.

ACTIVE CLEAR SOUND* button

Use the ACTIVE CLEAR SOUND (ACS) button to enhance the sound reproduction. Press the ACTIVE CLEAR SOUND button to turn it ON/ OFF.

* Active Clear Sound (ACS)

The Active Clear Sound (ACS) circuit emphasizes high-frequency sound without lowering the signal-noise ratio, while adjusting its output according to the input signal level. This results in a better balance between the high-frequency sound and the low-frequency heavy bass sound.

Main unit	Remote control unit
ACTIVE
CLEAR SOUND
	ACS
	ACS
ON	LEVEL
Lights when the ACS is ON.	Blinks depending on the volume level.

Sound mode button

Sound modes can be selected to enhance the type of music being played.

ÖPress the SOUND button to select the sound mode.

ÖEach time the SOUND button is pressed the sound mode changes as follows:

Main unit	Remote control unit
SOUND
	SOUND

ÖThe factory-preset is “FLAT”. Each time the SOUND button is pressed, the display changes as shown.

Sound mode selection

BEAT:

Set to this position for music with a heavy beat, such as rock or disco music.

POP:

Set to this position for light music including popular and vocal music.

CLEAR:

Set to this position for crisp and clear sounding music with transparent highs.

FLAT (No sound effect (flat characteristics)):

Set to this position when listening to classical music.

Note:

The selected modes only affect the sound output from the speakers or headphones. They do not affect the sound when recording.

12