Sharp AR-C250 operation manual Finisher AR-FN4, Offset stack, NON Offset mode

FINISHER (AR-FN4)

Offset stack

In the initial settings, the offset stack function is set to off. To enable the offset stack function, press the “OUTPUT” key and then touch the “OFFSET” icon on the touch panel. To disable the “OFFSET” function, press the “OUTPUT” key and then touch the “NON OFFSET” icon. When the offset function is selected, the output tray will move side to side each time a set is output so that each set is offset by approximately 0.8 inches (20 mm) from the previous set.

NOTE:

Some type or quality of paper might cause tight curl when it is output. In this case, remove the paper out of the paper tray or the bypass tray and reload it upside down.

Finisher (AROPTIONAL EQUIPMENT

-FN4)

CHAPTER7

READY TO COPY.

OUTPUTOK

		NON OFFSET	OFFSET
AUTO	AUTO	1	100%
		8/2 11
EXPOSURE	PAPER SELECT		COPY RATIO

READY TO COPY.

OUTPUTOK

		NON OFFSET	OFFSET
AUTO	AUTO	1	100%
		8/2 11
EXPOSURE	PAPER SELECT		COPY RATIO

OFFSET mode

When making copies, the output tray will shift from its previous position by approximately 0.8 inches (20 mm) each time a “START” key is pressed. In this way, the set in progress will be offset from the previous set. Copies in the size of 5-1/2" x 8-1/2", 8-1/2" x 11", 8-1/2" x 11"R, 8-1/2" x 13", 8-1/2" x 14" and 11"x 17" can be offset.

NON OFFSET mode

All copies will be aligned in one stack in the tray with no offset.

7-20