Sharp AR-C250 operation manual JOB Memory, Storing a job program, Press the Program key

JOB MEMORY

CHAPTER2

Frequently used job programs can be stored in one of nine storage registers. This is convenient for quick job recall without losing time manually reprogramming each aspect of the job.

●All functions that can be set in the copy mode except the copy quantity setting can be stored in the job memory.

●If any function which has been stored in a job program is modified by a key operator program, the key operator settings will supercede the previous setting.

★ KEY OPERATOR Job memory replacement/deletion can be prohibited. See page 28 of the KEY OPERATOR’S GUIDE.

MAKING COPIES Job memory

Storing a job program

8	9	1	Press the PROGRAM key.
			● The JOB PROGRAMS screen will appear on the touch panel.
IT	PROGRAM	C
0	P	CLEAR

1	2	3
4	5	6
7	8	9
RECALL		STORE/DELETE

Press the “STORE/DELETE” key on the touch panel.

2 ● To cancel the job memory mode, press the “EXIT” key or the CLEAR ALL ( CA ) key.

JOB PROGRAMS EXIT

PRESS PROGRAM NUMBER.

1 2 3

4 5 6

7 8 9

RECALL STORE/DELETE

MAKE COPIER SELECTIONS AND PRESS	OK
[OK].

1.81211

2.1117

3.81214

AUTO	AUTO	1	11	100%
		8/2
EXPOSURE	PAPER SELECT			COPY RATIO

Select a program number from 1 to 9 on the touch panel.

3 ● The numbers which are highlighted are job registers which already contain job programs.

●If a program number containing a registered job program is selected, a message will appear to confirm the selection. To replace a stored job program with a new program, press the “STORE” key and proceed to the next step.

To cancel replacement, press the “CANCEL” key.

4 Make all copier selections to be stored.

5 Press the “OK” key to complete the storage.

2-18