Using the microphone/guitar
Microphone/guitar mixing
Using a microphone or a guitar (not supplied), you can mix its sound with a source sound.
1. Make sure the MIC/GUITAR LEVEL control on the rear of the system is properly set.
•When using a microphone, make sure the knob is pressed in ( ).
•When using a guitar, make sure the knob is released ( ).
2. Set the MIC/GUITAR LEVEL control to MIN by turning it fully counterclockwise.
3. Connect a microphone or a guitar into the
MIC/GUITAR INPUT jack on the rear of the system.
4. Start a source: disc, tuner, iPod, or auxiliary equipment.
5. Adjust the VOLUME +/– control and the
MIC/GUITAR LEVEL control, as you play the microphone or the guitar.
CAUTION:
DO NOT connect a bass guitar to the MIC/ GUITAR INPUT jack, as it may damage the system.
Using the timer
| ON/STANDBY |
| CANCEL |
SLEEP | SET |
| CLOCK/TIMER |
4 | x |
The timers let you control the listening functions automatically.
Setting the clock
When the power is first supplied, the CLOCK indicator and “0:00” flash on the display. Set the clock.
Note:
The clock must be correctly set for the timers to work.
CAUTION:
If memory backup batteries are exhausted or not installed, and the AC power cord is plugged in again after being disconnected, or power is restored after a power failure, the CLOCK indicator will flash on the display. Set the current time (clock) again.
Using the remote control only
1. Press ON/STANDBY.
2. Press CLOCK/TIMER repeatedly until the
CLOCK indicator lights up.
The hour digit flashes on the display.
3. Press x or 4 to select the hour.
•When you press and hold the button, the hour digit changes continuously.
4. Press SET to set the hour.
The minutes digits start flashing on the display.
5. Press x or 4 to select the minute.
•When you press and hold the button, the minute digit changes continuously.
•If you want to change the hour setting, press CANCEL.
6. Press SET to finish setting the clock.
Setting the sleep timer
Use the sleep timer to turn the system off after a certain number of minutes when it is playing. By setting the sleep timer, you can fall asleep to the music and know that your system will turn off by itself rather than playing all night.
You can set the sleep timer only when the system is turned on.
Using the remote control only
1. Press SLEEP.
The SLEEP indicator lights up on the display.
SLEEP indicator
15