Basic operations
| ON/STANDBY | SUPER WOOFER |
| DISPLAY | |
| VOLUME +/– | |
|
| |
|
| SOUND |
| SUPER WOOFER | ON/STANDBY |
| VOLUME +/– | |
SOUND |
| |
MUTING |
| |
ACS |
| ACTIVE CLEAR |
| VOLUME +/– | SOUND |
VOLUME +/–
STANDBY lamp
ACS ON/LEVEL indicator
Turning the power on and off
Note: The lighting condition for the STANDBY lamp and for the display differs depending on the power source.
Power source | STANDBY lamp/display |
|
|
• AC power | • The STANDBY lamp lights when power is |
| turned off. |
| • Backlighting of the display is illuminated |
| when power is turned on. |
|
|
• Batteries or car | • The STANDBY lamp does not light. |
battery | • Backlighting of the display is not |
(DC12V)* | illuminated. |
•With the system turned off (at standby), no indication is shown on the display.
*If no source is playing and no operation is done for about 4 minutes, “DC OFF” starts flashing on the display for about one minute before the system turns off automatically (except when the source is FM/AM or AUX, or when the microphone/guitar is used).
Turning on the system
Press 
ON/STANDBY.
• When the system is operated on batteries or car battery (DC12V),
Turning off the system
Press 
ON/STANDBY again.
The STANDBY lamp lights up when the system is operated on AC power.
•When the AC power is used, the CLOCK indicator and the time are displayed without backlighting.
or
On system | On remote control |
Some power is always consumed even though power is turned off (called standby mode).
To disconnect the system from mains (AC) supply completely, unplug the AC power cord from the AC outlet. When you unplug the AC power cord, the clock will be reset to “AM12:00” if no memory backup batteries are installed.
Adjusting the volume
You can adjust the volume level between 0 and 50.
Using the system
press 
ON/STANDBY on the system.
The STANDBY lamp goes off when the system is operated on AC power.
The display comes on and the system is ready to continue in the mode it was in when the power was last turned off.
Turn the VOLUME +/– control clockwise to increase the volume or turn it counterclockwise to decrease the volume.
or
On system | On remote control |
Using the remote control
Press VOLUME + to increase the volume or press VOLUME – to decrease it.
When you press and hold VOLUME + or
CAUTION:
DO NOT start playing any source without setting the volume to minimum first, as a sudden blast of sound can damage your hearing, speakers and/or headphones.
For private listening
Connect a pair of headphones to the PHONES jack on the rear of the system (see page 5). No sound comes out of the speakers. Be sure to turn down the volume before connecting or putting on the headphones.
7
