6.Press Control % / Þ until
7.Press Control @/ # to adjust the delay time of the rear speaker output. Each time you press the button, the delay time changes as follows:
DELAY 1 DELAY 2 DELAY 3
DELAY 1 | Select this when the distance from you to your rear speakers is greater than that to the |
| front speakers. |
DELAY 2 | Select this when the distance from you to your rear speakers is almost equal to that to |
| the front speakers. |
DELAY 3 | Select this when the distance from you to your rear speakers is less than that to the front |
| speakers. |
|
|
Note:
When you have selected “3CHLOGIC,” you cannot adjust the delay time.
8. Press Control % / Þ until “TEST” appears on the display, then press Control @/ # to start checking the speaker output balance.
“TEST” starts flashing on the display, and a test tone comes out of the speakers in the following order:
Left front |
| Center |
| Right front |
speaker |
| speaker |
| speaker |
Rear speakers
Notes:
•No test tone comes out of the rear speakers when you have selected “3CHLOGIC.”
•No test tone comes out of the center speaker when you select “PHANTOM” or “OFF” for the center mode.
9.If necessary, adjust the speaker output balance as follows:
•To adjust the rear speaker output level, press Control % / Þuntil “– REAR +” appears on the display, then press Control @ / #.
•To adjust the center speaker output level, press Control %/ Þ until
Notes:
•The sound levels of the left and right rear speakers will be the same.
•You cannot set the sound level of the rear speakers when you have selected “3CHLOGIC.”
•You cannot set the sound level of the center speaker when you select “PHANTOM” or “OFF” for the center mode.
10. Press Control % / Þ until “TEST” appears on the display, then press Control @/ # to stop the test tone.
English
Page 24