JVC RX-5000VBK Receiving Radio Broadcasts, Ch, Tuning in Stations Manually, Using Preset Tuning

Receiving Radio Broadcasts

You can browse through all the stations or use the preset function to go immediately to a particular station.

Tuning in Stations Manually

On the front panel ONLY:

1. Press FM or AM.

The last station of the selected band is tuned in.

•The MULTI CURSOR %/ Þ / @/ #buttons can be now used for operating the tuner.

2.Press MULTI CURSOR %/ Þ repeatedly until “–TUNING+” appears on the display.

FM

AM

MULTI CURSOR

MULTI CURSOR

Using Preset Tuning

Once a station is assigned to a channel number, the station can be quickly tuned. You can preset up to 30 FM stations and 15 AM stations.

To store the preset stations

Before you start, remember...

•There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 1 again.

On the front panel ONLY:

1. Tune in the station you want to preset (see “Tuning in Stations Manually”).

If you want to store the FM reception mode for this station, select the FM reception mode you want. See “Selecting the FM Reception Mode” on page 14.

2. Press MEMORY. MEMORY

3.Press MULTI CURSOR @/ # until you find the frequency you want.

•Pressing @decreases the frequency.

•Pressing #increases the frequency.

Notes:

•When you hold MULTI CURSOR @ / # in step 3, the frequency keeps changing until a station is tuned in.

•When a station of sufficient signal strength is tuned in, the TUNED indicator lights up on the display.

When an FM stereo program is received, the STEREO indicator also lights up.

“CH-” appears and the channel number position starts flashing on the display for about 5 seconds.

CH- _ _

MULTI CURSOR

3.Press MULTI CURSOR @/ #to select a channel number while the channel number position is flashing.

Note:

You can use the 10 keys on the remote control to select the preset number. When using the 10 keys, be sure that they are activated for the tuner, not for the CD and others. (See page 22.)

4. Press MEMORY again while the selected channel number is flashing on the display.

MEMORY

The selected channel number stops flashing.

The station is assigned to the selected channel number.

5.Repeat steps 1 to 4 until you store all the stations you want.

To erase a stored preset station

Storing a new station on a used number erases the previously stored one.

13