Using the DVD MULTI Playback Mode, English

Using the DVD MULTI Playback Mode

This receiver provides the DVD MULTI playback mode for reproducing the analog discrete output mode of the DVD player. Before playing back a DVD, refer also to the manual supplied with the DVD player.

English

Activating the DVD MULTI Playback Mode

You can adjust the DVD MULTI playback mode while playing back a DVD using the analog discrete output mode on the DVD player. Once you made adjustments, the receiver memorizes the

MULTI CURSOR

7.Press MULTI CURSOR @/ #to adjust the left rear speaker output level (from –10 to +10).

adjustments until you change them.

Before you start, remember...

•Make sure that you have set the speaker information correctly (see page 11).

•There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 1 again.

•You can only adjust the rear and/or center speaker output levels when you have connected rear speakers and/or a center speaker and have set “REAR SPK” and/or “CNTR SPK” correctly. See page 11.

8.Press MULTI CURSOR %/ Þ repeatedly until “–REAR R+” appears on the display.

9.Press MULTI CURSOR @/ #to adjust the right rear speaker output level (from –10 to +10).

MULTI CURSOR

On the front panel:

DVD MULTI

1. Press DVD MULTI .

Note:

When you select “DVDMULTI” as the source to play, the DSP mode is canceled temporarily, and the SURROUND button does not work.

From the remote control:

1. Press DVD MULTI.	DVD MULTI

Note:

When you select “DVDMULTI” as the source to play, the DSP mode is canceled temporarily, and the SURROUND button does not work.

2.Select the analog discrete output mode on the DVD player, and start playing a DVD.

• Refer to the manual supplied with the DVD player.

If you need to make any adjustment, go to the following steps.

3. Press ADJUST so that MULTI	ADJUST
CURSOR %/ Þ/ @/ #buttons
work for adjusting the DVD
MULTI playback setting.

2.Select the analog discrete output mode on the DVD player, and start playing a DVD.

• Refer to the manual supplied with the DVD player.

If you need to make any adjustment, go to the following steps.

3. Press SOUND CONTROL.	SOUND
	CONTROL

The 10 keys are activated for adjusting the sound.

4. Press CENTER – / + to adjust the – CENTER +		5
5	6

4. Press MULTI CURSOR %/ Þ

repeatedly until “–CENTER+”

appears on the display.

MULTI CURSOR

center speaker output level.

•Pressing CENTER – decreases the output level up to –10 dB.

•Pressing CENTER + increases the output level up to +10 dB.

5.	Press MULTI CURSOR @/ #to
	adjust the center speaker output
	level (from –10 to +10).
6.	Press MULTI CURSOR %/ Þ
	repeatedly until “–REAR L+”
	appears on the display.