JVC RX-5001VGD manual Repeatedly until -CENTER+ Appears on the display, Activating the DSP Modes

DOLBY SURROUND

DOLBY SURROUND

English

On the front panel:

You can also use the buttons on the front panel to adjust the Surround modes. However, no test tone is available when using the buttons on the front panel. So, make adjustments while listening to the sound of the source played back.

8.ONLY FOR JVC Theater Surround:

Press MULTI CURSOR @/ #to select an effect level you want.

MULTI CURSOR

• Each time you press the button, the effect

1. Press SURROUND repeatedly until the mode — “PROLOGIC,” “3 STEREO,” or “THEATER”— appears on the display.

SURROUND

level changes as follows:

EFFECT 1 EFFECT 2 EFFECT 3

The PRO LOGIC indicator lights up on the display.

2. Press ADJUST so that MULTI	ADJUST
CURSOR %/ Þ/ @/ #buttons
work for adjusting the DSP
setting.
3. Press MULTI CURSOR %/ Þ	MULTI CURSOR
repeatedly until “–CENTER+”
appears on the display.
	MULTI CURSOR

4.Press MULTI CURSOR @/ #to adjust the center speaker output level (from –10 to +10).

MULTI CURSOR

5. Press MULTI CURSOR %/ Þ repeatedly until “– REAR +” appears on the display.

EFFECT 5 EFFECT 4

As the number increases, JVC Theater Surround becomes stronger.

Activating the DSP Modes

Once you have finished adjustments for the DSP modes, you can use the same adjustments every time you want to use these modes.

On the front panel:

SURROUND

1. Press SURROUND repeatedly until the DSP mode you want appears on the display.

•Each time you press the button, the DSP modes change. (See page 16 for more details.)

2.Select and play a sound source.

•To enjoy the 3D-PHONIC, Dolby Surround, and JVC Theater Surround, play back a software which was processed with

Dolby Surround and is labeled with mark.

To cancel the DSP mode

Press SURROUND repeatedly until “OFF” appears on the display.

MULTI CURSOR

6. Press MULTI CURSOR @/ #to adjust the rear speaker output level (from –10 to +10).

Note:

You cannot adjust the left and right rear speaker output levels separately.

7. ONLY FOR JVC Theater	MULTI CURSOR
Surround:

From the remote control:

1. Press SOUND CONTROL.

The 10 keys are activated for sound adjustments.

2.Press SURROUND repeatedly until the DSP mode you want appears on the display.

•Each time you press the button, the DSP modes change. (See page 16 for more details.)

SOUND

CONTROL

SURROUND

3

Press MULTI CURSOR %/ Þ repeatedly until “–EFFECT+” appears on the display.

3. Select and play a sound source.

•To enjoy the 3D-PHONIC, Dolby Surround, and JVC Theater Surround, play back a software which was processed with

Dolby Surround and is labeled with mark.

To cancel the DSP mode

Press SURROUND repeatedly until “OFF” appears on the display in step 2 above.

19