JVC RX-6010VBK manual Adjusting the Subwoofer Output Level, Adjusting the Tone

Adjusting the Subwoofer Output Level

You can adjust the subwoofer output level if you have selected “YES” for the “SUBWOOFER” (see page 11).

Once it has been adjusted, the receiver memorizes the adjustment.

Before you start, remember...

•There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 1 again.

•When the front speakers are deactivated, the subwoofer level cannot be adjusted.

On the front panel:

1. Press ADJUST repeatedly until	ADJUST SETTIN
“SUBWFR LEVEL” appears on
the display.

The display changes to show the current setting.

SPK

ANALOG L R

S.WFR

2. Press CONTROL UP 5/DOWN °		CONTROL
		DOWN UP
to adjust the subwoofer output
level (+10 dB to –10 dB).
	SPK
	ANALOG L R
	S.WFR

	SPK	INPUT ATT
ANALOG	L	R

SPK

ANALOG L R

Notes:

•This function is available only for the sources connected using the analog terminals.

•This function does not take effect when digital input is selected.

Adjusting the Tone

You can adjust the bass and treble sounds as you like.

Once it has been adjusted, the receiver memorizes the adjustment.

Before you start, remember...

•There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 1 again.

On the front panel ONLY:

1. Press ADJUST repeatedly until	ADJUST SETTIN
“BASS” or “TREBLE” appears on
the display.

English

From the remote control:

1. Press SOUND.

The 10 keys are activated for sound adjustments.

2.Press SUBWOOFER +/– to adjust the subwoofer output level (+10 dB to –10 dB).

SOUND

– SUBWOOFER +

2 3

•Select “BASS” to adjust the bass sound level.

•Select “TREBLE” to adjust the treble sound level.

SPK

ANALOG L R

or

SPK

ANALOG L R

Attenuating the Input Signal

When the input level of the playing source is too high, the sounds will be distorted. If this happens, you need to attenuate the input signal level to prevent the sound distortion.

Once it has been adjusted, the receiver memorizes the adjustment.

On the front panel ONLY:

Press and hold INPUT ATT so that	INPUT ANALOG
the INPUT ATT indicator lights up	INPUT ATT
on the display.

•Each time you press and hold the button, the Input Attenuator mode turns on (“INPUT ATT ON”) or off (“INPUT NORMAL”).

2.Press CONTROL UP 5/DOWN ° to adjust the bass or treble sound level (+10 dB to –10 dB).

•Each time you press the button, the sound level changes by ± 2 steps.

CONTROL

DOWN UP

10