Notes:
•Noise may come out of the speakers while searching or skipping a
•When you change the source, the digital input mode will be automatically reset to “AUTO/PCM.”
Showing the Text Information on the
Display
When you have connected an MD recorder or CD player equipped with TEXT COMPU LINK remote control system (see page 36), you can show the text information, such as disc title or track title, on the display of this receiver. To show it on the display, follow the procedure below.
Before you start, remember....
•There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 1 again.
On the front panel only:
SETTING
1.Press SETTING repeatedly until “FL DISPLAY” appears on the
display.
The display changes to show the current setting.
2. Turn MULTI JOG to select either | MULTI JOG |
the source name or the text |
|
information to be shown on the |
|
display. |
|
•As you turn it, the display changes to show the following:
NORMAL TEXT
NORMAL: Source name appears during play.
TEXT: Text information appears during play.
Note:
Though you have selected “TEXT,” the source name such as “CD” or
“MD” appears if a playing disc has no text information.
Storing the Basic Settings and Adjustments — One Touch Operation
JVC’s One Touch Operation function is used to assign and store different sound settings for each different playing source. By using this function, you do not have to change the settings every time you change the source. The stored settings for the newly selected source are automatically recalled.
The following can be stored for each source:
•Volume level (see page 11)
•Bass boost (see page 12)
•Input attenuator mode (see page 12)
•Subwoofer output level (see page 12)
•Balance (see page 13)
•SEA modes (see page 20)
•DSP modes
–
–DAP mode settings (see page 24)
–Surround mode settings (see page 25)
•DVD MULTI playback mode settings (see page 29)
On the front panel ONLY: |
|
To store the sound settings | ONETOUCHOPERATION |
|
1. Press ONE TOUCH OPERATION.
The ONE TOUCH OPERATION lamp lights up, then the previously memorized settings are recalled.
2. Adjust the sound using the functions listed above.
The newly adjusted settings are memorized.
To recall the sound settings
With the ONE TOUCH OPERATION lamp lit, the settings for the currently selected source are recalled when the source is selected.
To cancel the One Touch Operation function
Press ONE TOUCH OPERATION so that the lamp goes off. (Even though the One Touch Operation function is canceled, the recalled sound effects remain active.)
Notes:
•If the source is FM or AM, you can assign a different setting for each band.
•The DSP modes and DVD MULTI playback mode cannot be used at the same time.
Using the Sleep Timer
Using the Sleep Timer, you can fall asleep to music and know the receiver will turn off by itself rather than play all night.
From the remote control ONLY:
SLEEP
Press SLEEP repeatedly.
The SLEEP indicator lights up on the display, and the
10 20 30 40 50 60 70 80 90
00(Canceled)
When the shut-off time comes
The receiver turns off automatically.
To check or change the time remaining until the
Press SLEEP once.
The remaining time until the
• To change the
To cancel the Sleep Timer
Press SLEEP repeatedly until “SLEEP 00min.” appears on the display. (The SLEEP indicator goes off.)
• Turning off the power also cancels the Sleep Timer.
17