Troubleshooting
Use this chart to help you solve daily operational problems. If there is any problem you cannot solve, contact your JVC service center.
PROBLEM | POSSIBLE CAUSE | SOLUTION |
|
|
|
The display does not light up. | The power cord is not plugged in. | Plug the power cord into an AC outlet. |
|
|
|
No sound from speakers. | Speaker signal cables are not connected. | Check speaker wiring and reconnect if |
|
| necessary. |
The SPEAKERS 1 and 2 buttons are not set correctly.
Press SPEAKERS 1 and 2 correctly.
An incorrect source is selected. | Select the correct source. |
|
|
Muting is activated. | Press MUTING to cancel the mute. |
Sound from one speaker only.
Speaker signal cables are not connected properly.
Check speaker wiring and reconnect if necessary.
The balance is set to one extreme. | Adjust the balance properly (see page 13). |
Continuous hiss or buzzing during FM reception.
Incoming signal is too weak.
Connect an outdoor FM antenna or contact your dealer.
The station is too far away. | Select a new station. |
An incorrect antenna is used.
Check with your dealer to be sure you have the correct antenna.
| Antennas are not connected properly. | Check connections. |
|
|
|
Occasional cracking noise during FM | Ignition noise from automobiles. | Move the antenna farther from automobile |
reception. |
| traffic. |
No colors on the
The color system of the connected TV is | Connect an NTSC TV. |
not NTSC. |
|
Howling during record playing. | Your turntable is too close to speakers. | Move speakers away from the turntable. |
“OVERLOAD” starts flashing on the display.
Speakers are overloaded because of high volume.
1.Press POWER on the front panel to turn off the receiver.
2.Stop the playback source.
3.Turn on the receiver again, and adjust the volume.
Speakers are overloaded because of short circuit of speaker terminals.
Press POWER on the front panel, then check the speaker wiring.
If “OVERLOAD” does not disappear, unplug the AC power cord, then plug it back again.
If speaker wiring is not
Remote control does not work.
The remote control mode selector is not | Set the selector correctly either to “AUDIO/ |
set correctly. | TV/VCR” or to “CATV/DBS.” |
|
|
There is an obstruction in front of the | Remove the obstruction. |
remote sensor on the receiver. |
|
Batteries are weak. | Replace batteries. |
|
|
48
