Antunes, AJ VCT-1000 owner manual Troubleshooting

VERTICAL CONTACT TOASTER

TROUBLESHOOTING (continued)

Problem	Possible Cause	Corrective Action
Product is overly-toast-	Temperature set too high.	Set temperature control to a lower setting.
ed or Platen heat is too
	Bun Thickness Compression	Measure bun thickness and set Bun Thickness
high or drop time is too	Knobs set improperly.	Compression Knobs correctly (Figure 7).
slow.
	Buns sticking on Release Sheet.	Clean or replace Release Sheet according to the pro-
		cedure in the Maintenance section of this manual.
	Conveyor Cover Assembly not	Re-install Conveyor Cover Assembly.
	installed properly.
	Loose sprocket setscrews.	Check drive chain for kinks, broken or bent links,
		or other damage. Check motor sprocket and drive
		sprockets; tighten setscrew on flat of shaft if required.
		Check for damaged/worn sprocket and replace as
		required.
	Conveyor Belt Chain too loose.	Adjust Conveyor Belt Chain length as described in the
		Maintenance section of this manual.
	Spring Tensioner Assembly or	Replace Spring Tensioner Assembly or Roller
	Roller Tensioner is damaged or	Tensioner if damaged or missing.
	missing.
Product is under toast-	Bun Thickness Compression	Measure bun thickness and set Bun Thickness
ed or Platen heat is too	Knobs set improperly.	Compression Knobs correctly.
low or drop time is too
	Wiring problem.	Contact your maintenance person or Authorized
fast.		Service Agency for service.
	Inoperable Thermostat.
	Conveyor Drive Motor inoper-
	able or incorrect conveyor motor
	installed in toaster.
Product is getting	Bun Thickness Compression	Measure bun thickness and set Bun Thickness
stuck or Conveyor Belt	Knobs Set improperly.	Compression Knobs correctly.
Chains stop when prod-
	Release Sheet not cleaned	Clean or replace Release Sheet as described in the
uct is toasting.	properly or is missing.	Maintenance section of this manual..
	Conveyor Drive motor inopera-	Contact your maintenance person or Authorized
	tive or incorrect conveyor motor	Service Agency for service.
	installed in toaster.
	Conveyor Drive Chain loose,	Check drive chain for kinks, broken or bent links,
	worn, or broken. Loose motor	or other damage. Check motor sprocket and drive
	drive sprocket.	sprockets, tighten setscrew on flat of shaft if required.
		Check for damaged/worn sprockets and replace as
		required.
	Conveyor Belt Chain too loose.	Adjust Conveyor Belt Chain length as described in the
		Maintenance section of this manual.
	Spring Tensioner Assembly or	Replace Spring Tensioner Assembly or Roller
	Roller Tensioner is damaged or	Tensioner if damaged or missing.
	missing.

16 P/N 1010807 Rev. E 06/06