VERTICAL CONTACT TOASTER
INSTALLATION
Unpacking
1.Remove unit and all packing materials from ship- ping carton.
2.Open the large box. It should contain:
•Bun Feeder (Figure 1).
•Bun Chute (Figure 2)
•2 Release Sheets (Figure 1).
•Authorized Service Agency Directory
•Owner’s Manual
3.Remove all packing materials and protective cov- erings from the unit and parts.
NOTE: If any parts are missing or damaged, con- tact Antunes Technical Service IMMEDIATELY at
Heat
Shield
Platen
Yellow Support Rod (front)
Front Conveyor Belt Chain
Bun
Feeder
Release
Sheet
Rear Conveyor 
Belt Chain Yellow 
Support Rod 
(rear)
Conveyor
Interlock Switch
Assembling the Unit
NOTE: The factory has
CAUTION 
Failure to use Release Sheets may result in damage
Conveyor | Conveyor |
Cover Assy. | |
Cover Assy. | (rear) |
(rear) |
|
| Shown without option- |
| al Roller Tensioners |
| and Belt Wraps. |
Figure 1. Toaster and Accessories
to the unit and loss of warranty coverage.
1.Install the Bun Feeder (Figure 1) and Bun Chute (Figure 2).
IMPORTANT: Make sure Heat Shield Assembly is properly seated and engages the Conveyor Interlock Safety Switch (see Figure 1). The con- veyors will not rotate unless the Heat Shield is in place and correctly engages the Conveyor Interlock Safety Switch.
NOTE: Check the Release Sheet to make sure it is not caught in the conveyor. Additional Release Sheets can be obtained through your authorized service agency under part no. 7000249 (3 pack) or 7000250 (10 pack).
Hook Bun Chute over rear bottom conveyor cover yellow support rod
Yellow
Support
Rod
Conveyor Cover Assy. (front)
Shown without optional
Roller Tensioners and Belt Wraps.
Bun Feeder.
Heat
Shield
Conveyor Cover Assy. (rear)
Bun Chute
Figure 2. Installing Bun Chute
P/N 1010807 Rev. E 06/06 | 7 |
