VERTICAL CONTACT TOASTER
INSTALLATION (continued)
Installing the Optional Belt Wraps and Roller Tensioners
NOTE: Beltwraps and Roller Tensioners are REQUIRED on models with manufacturing number 9210716 and 9210722.
INSTALLING BELT WRAPS
NOTE: Depending on toaster usage and how well they are cleaned daily, the Belt Wraps should last between 3 - 6 months. Additional Belt Wraps may be purchased from your Authorized Service Agency.
Upper Yellow Support Rod | Belt Rotation |
Lower Yellow | ION |
CAUT | |
| |
Support Rod |
|
| Belt Wrap |
| Pin |
1.Ensure that the Rocker Switch (power On/Off) is set to OFF, the power cord is unplugged, and the unit is cool before proceeding.
2.Remove the Bun Feeder and Heat Shield and set the Bun Thickness Compression Knobs to 6 and 6 (Figure 7).
3.Open both Conveyor Covers and install the Belt Wraps around the Conveyor Belt Chains inside the yellow rods with the “zipper” flap exposed and hanging down (Figures 3 & 4).
4.Close the Conveyor Cover(s), set the Compression Control Knobs back to their normal settings and reinstall the Heat Shield and Bun Feeder.
INSTALLING OPTIONAL ROLLER TENSIONERS
1.Install the Tensioner Assembly and reassemble the unit (Figure 5).
2.Make sure the spacers are placed inside the Tensioner arm. The spacers are smaller than the holes to allow the Tensioner to pivot freely.
Figure 3. Installing Optional Belt Wraps
INCORRECT CORRECT
Figure 4. Aligning Belt Teeth
| CAUTION |
Align the ends of the Belt Wrap properly (Figure 13) | |
or the Belt Wrap may be damaged. | |
| CAUTION |
Position the Belt Wrap UNDER the upper and lower | |
yellow support rods or damage to the unit may occur. | |
Acorn Nuts | Weld |
| |
| Screws |
Tensioner |
|
Assy. |
|
| Spacers |
| Teflon |
| Tape |
Figure 5 Installing Optional Roller Tensioner | |
| Assembly |
8 | P/N 1010807 Rev. E 06/06 |
