User instructions
6. Troubleshooting
The dishwasher is equipped with a
FAULT
E1
E2 - E9
E3
E4
E5
E6
E7
E8
TABLE OF FAULTS DETECTED BY THE
DESCRIPTION
The
The water level limitation system has tripped.
The appliance cannot heat the water.
The temperature sensor is disconnected.
The appliance cannot take in the water.
The appliance cannot drain the water from the tank.
The dishwasher cannot measure the precise water quantity that has been loaded.
Problem on the water distribution system to the baskets.
•The E1, E2, E3, E4, E8, E9 alarms provoke the “forcing” to end cycle of the running program.
•The E5, E6 alarms interrupts the running program once the cause is resolved, it will bring bach the execution of the program.
•The alarm E7 is visualized at the end of the cycle that comes, however, brought to the end since the operation of the dishwasher is not harmed.
To “reset” an alarm is necessary:
•Open and close the door, or turn off and on the machine. At this point is possible to program the dishwasher again.
If the malfunction persists, contact your authorised Service Centre.
TECHNICAL DATA
Width
Depth measured flush with the outer edge of the control panel
597 ⎟ 599 mm
Free standing: 600 mm
Height |
| from 850 mm to 870 mm |
|
|
|
Capacity |
| 14 Standard place settings |
|
|
|
Water supply pressure |
| min. 50 – max. 900 KPa (min. 0.5 – max. 9 bar) |
|
|
|
Electrical characteristics |
| See rating plate |
45