User instructions
START PROGRAM
At this point, in order to start the machine, it is only enough to press the START/PAUSE (6) for some seconds until the writtin “Time to end” start to flash and confirmation “beep” is heard. From this moment the cycle dration on the DISPLAY (9) starts to decrease.
This phase, that updates itself during the cycle, is “indicative” since it is influenced by the washing conditions such as dishwasher type and quantity, entry temperature etc. For this reason it is normal to see the updating during a program (increment and decrease of minutes) specially in the passage from one phase to the other (for example, from washing to rinse).
END PROGRAM
The end of the program is indicated by a short signal acoustic and from the “End” visual notification on DISPLAY (9). By pressing one of the buttons, the “End” visual signal will vanish from the display and the dishwasher is ready to continue a new cycle, the same thing happens when closing or opening the door or by switching
INTERRUPTING A PROGRAM
In order to interrupt a running program it is necessary:
•to press the START/STOP (6) for some seconds until when the writting “Time to end” remains lit on the display (confirmation beep). At this point,it is possible to start the cycle again, otherwise:
TO CHANGE A PROGRAM
To change the running program it is necessary:
•to interrupt the running program (see “INTERRUPTING A PROGRAM”);
•select the new program;
•to press again the START/STOP button (6) to make start the new program.
STOPPING A PROGRAM
To stop a program in progress, it must first be interrupted (see "INTERRUPTING A PROGRAM").
Now press buttons P1+P2 simultaneously and the first three program lights will come on.
The display will show "P0" and the dishwasher will immediately switch to the end of the cycle and drain the tank (during this process, the "Time to end" message will flash).
When the drain procedure ends, the end of cycle message "End" appears on the display.
In case that the door is opened during the operation, to the next door closing it is going to be necessary to start the program as shown in paragraph “START PROGRAM”. The program will resume from the point in which it was interrupted.
In case that the tub temperature is higher than 50°C the program will start 30 seconds later the door closing (this, in order to avoid overpressure phenomenom inside the tub).
31
