Receiving Radio Broadcasts

You can browse through all the stations or use the preset function to go immediately to a particular station.

Tuning in to Stations Manually

Using Preset Tuning

English

1. Press FM or AM to select the band.

The last received station of the selected band is tuned in.

 

ANALOG

TUNED STEREO

L

R

LINEAR PCM

SPEAKERS 1

VOLUME

2.Press FM/AM TUNING 5 or repeatedly until you find the frequency you want.

Pressing FM/AM TUNING 5 increases the frequency.

Pressing FM/AM TUNING decreases the frequency.

 

ANALOG

TUNED STEREO

L

R

LINEAR PCM

SPEAKERS 1

VOLUME

Notes:

When a station of sufficient signal strength is tuned in, the TUNED indicator lights up on the display.

When an FM stereo program is received, the STEREO indicator also lights up.

When you hold and then release the button in step 2, the frequency keeps changing until a station is tuned in.

From the remote control:

1.Press FM/AM.

Each time you press the button, the band alternates between FM and AM.

2.Press TUNING UP or TUNING DOWN repeatedly until you find the frequency you want.

Pressing TUNING UP increases the frequency.

Pressing TUNING DOWN decreases the frequency.

Once a station is assigned to a channel number, the station can be quickly tuned in. You can preset up to 30 FM and 15 AM stations.

To store the preset stations

Before you start, remember...

There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 2 again.

On the front panel ONLY:

1.Tune in the station you want to preset (see “Tuning in to Stations Manually” on the left).

If you want to store the FM reception mode for this station, select the FM reception mode you want. See “Selecting the FM Reception Mode” on page 24.

2.Press MEMORY.

 

ANALOG

TUNED STEREO

L

R

LINEAR PCM

SPEAKERS 1

VOLUME

The channel number position starts flashing on the display for about 10 seconds.

3.Press FM/AM PRESET 5 or to select a channel number while the channel number position is flashing.

 

ANALOG

TUNED STEREO

L

R

LINEAR PCM

SPEAKERS 1

VOLUME

4. Press MEMORY again while the selected channel number is flashing on the display.

The selected channel number stops flashing.

The station is assigned to the selected channel number.

5.Repeat steps 1 to 4 until you store all the stations you want.

To erase a stored preset station

Storing a new station on a used number erases the previously stored one

23

Page 84
Image 84
JVC RX-8030VBK, RX-7030VBK manual Receiving Radio Broadcasts