Advanced operations
See page 22 for button locations.
Sound and other settings
IMPORTANT
Before using the remote control for the following operation;
• Set the remote control mode selector to
AUDIO.
NOTE
Before you start operation;
•There is a time limit when doing the following steps. If the setting is cancelled before you finish, start from step 1 again.
1 Press SETTING.
Example:
B A L : C E N T E R
2 Press Cursor Y/5 to select the item you want to set.
•BAL (Balance):
You can adjust the balance between the front left and front right speakers.
•DEC (Decode):
When you play an external source (AUX DIGITAL is selected as a source) that was encoded with Dolby Digital or DTS Digital Surround, the following symptoms may occur;
•No sound comes out at the beginning of playback.
•Noise comes out while searching for or skipping chapters
or tracks.
AUT/PCM (Auto/PCM):
Normally select this. The system automatically detects the incoming signals.
DOLBY D: Select this if the symptoms above occur when playing a disc (or software) encoded with Dolby Digital.
DTS: Select this if the symptoms above occur when playing a disc (or software) encoded with DTS Digital Surround.
3 Press Cursor 3/2 to make an adjustment or selection.
Example:
B A L : R -- 5
The adjustment is set and the display automatically disappears a few seconds later.
NOTE
•When “DOLBY D” or “DTS” is selected, if a signal encoded with another digital format comes in, you cannot listen to the sound. (The GDIGITAL or C indicator flashes.)
33
