JVC A-UXP38V, SP-UXP38V manual Recording, Check the recording direction for the tape, Press REC

Recording

IMPORTANT: Recording on a Tape

• It may be unlawful to record or playback copyrighted

English

material without the consent of the copyright owner.

•The recording level is automatically set correctly, so it is not affected by the VOLUME, AHB (Active Hyper Bass) PRO, and SOUND MODE settings. Thus, during recording you can adjust the sound you are actually listening to without affecting the recording level.

•If recordings you have made have excessive noise or static, the unit may be too close to a TV. Increase the distance between the TV and the unit.

•You can use type I tape for recording.

To protect your recording

Cassettes have two small tabs on the back to protect from unexpected erasure or re-

recording.

To protect your recording, remove these tabs.

To re-record on a protected tape, cover the holes with adhesive tape.

To keep the best recording and playback sound quality

If the heads, capstans, and pinch rollers of the cassette decks become dirty, the following will occur:

•Impaired sound quality

•Discontinuous sound

•Fading

•Incomplete erasure

•Difficulty in recording

To clean the heads, capstans, and pinch rollers

Use a cotton swab moistened with alcohol.

Capstans

Heads

Pinch rollers

To demagnetize the heads

Turn off the unit, and use a head demagnetizer (available at electronics and audio shops).

On the unit ONLY:

1 Put a recordable cassette in with the exposed part of the tape down.

2 Close the cassette holder gently.

•If you want to record on both sides of a tape, see “To record on both sides — Reverse Mode.”

3 Check the recording direction for the tape.

•If the tape direction is not correct, press TAPE2 3 twice then 7 to change the tape direction.

4 Start playing the source — FM, AM or auxiliary equipment connected to AUX jacks.

•When the source is CD, see “CD Direct Recording” on page 21.

5 Press REC.

The REC indicator lights up on the display and recording starts.

To stop recording, press 7.

To remove the cassette, press 0 for cassette deck.

To record on both sides — Reverse Mode

Press REV.MODE on the unit until the indicator is lit.

•When using the reverse mode for recording, start recording in the forward (3) direction first. Otherwise, recording will stop when recording is done only on one side (reverse) of the tape.

At the start and end of cassette tapes

There is leader tape which cannot be recorded onto. Thus, when recording CDs or radio broadcasts, wind on the leader tape first to ensure that the recording will be made without any music part lost.

– 20 –