Connecting Speakers, AM antenna | JVC SP-UXP5, CA-FSP5 manual

AM antenna	Connecting Speakers

]]

1	2
	3

ANTENNA

1

Vinyl-covered wire (not supplied)

Red

AM EXT

AM LOOP

FM 75

COAXIAL

2

AM loop antenna (supplied)

1Connect the AM loop antenna to the AM

LOOP terminals as illustrated.

• If the AM loop antenna wire is covered with vinyl, remove the vinyl by twisting it as shown in the diagram.

2Turn the AM loop antenna until you have the best reception.

To connect an outdoor AM antenna

When reception is poor, connect a single vinyl-covered wire to the AM EXT terminal and extend it horizontally. (The AM loop antenna must remain connected.)

For better reception of both FM and AM

•Make sure the antenna conductors do not touch any other terminals and connecting cords.

•Keep the antennas away from metallic parts of the unit, connecting cords, and the AC power cord.

RIGHT	LEFT
	MAIN
	SPEAKERS
SPEAKER
IMPEDANCE	Black
MIN 6	Black
Speaker cords
Right	Left
speaker	speaker

1Press and hold the clamp of the speaker terminal on the rear of the unit.

2Insert the end of the speaker cord into the

terminal.

Match the polarity of the speaker terminals: Red (+) to red (+) and black (–) to black (–).

3Release the finger from the clamp.

IMPORTANT: Use only speakers with the same speaker impedance as indicated by the speaker terminals on the rear of the unit.

– 7 –

Image 10

JVC SP-UXP5, CA-FSP5 manual Connecting Speakers, Turn the AM loop antenna until you have the best reception, AM antenna

Contents

Compact Component System Mises en garde, précautions et indications diverses Instructions for safe use Introduction PrecautionsAbout This Manual Contents Front Panel Location of the Buttons and ControlsFront Panel Become familiar with the buttons and controls on your unit Display Window Front Panel Display Window Remote Control Remote Control Supplied Accessories Connecting Antennas Getting Started Release the finger from the clamp Connecting SpeakersTurn the AM loop antenna until you have the best reception AM antenna To remove the speaker grilles Connecting Other EquipmentBy using audio cords not supplied, connect To connect audio equipment Common Operations Turning On the PowerSetting the Clock Selecting the Sources and Starting Play Reinforcing the Bass Sound Adjusting the VolumeSelecting the Display Brightness Selecting the Sound Modes Tuning in a Preset Station Tuning in a StationPresetting Stations Listening to FM and AM Broadcasts Basic CD Operations Playing Back CDs CD/CD-R/CD-RWPlaying Back the Entire CD Normal Play Press CD 3/8 Press Prog program On the remote control only Load a CDProgram Play Repeat to program other tracks you Repeating Tracks Repeat Play Playing at Random Random PlayProhibiting Disc Ejection Tray Lock On the unit only Playing Back a Tape To play both sides Reverse ModePlaying Back Tapes Press 0for cassette deck Check the recording direction for the tape RecordingRecording on a Tape Press REC Repeat steps 2 and 3 to record other tracks you want CD Direct RecordingOne Track Recording To stop CD Direct Recording, press 7. The tape stops after Using the Timers Using Daily Timer and Recording Timer How Sleep Timer actually works Using Sleep TimerOn the remote control only Press Sleep Wait for about 5 seconds after specifying the time length Troubleshooting Symptom Handling discs MaintenanceCleaning the unit Handling cassette tapes Specifications Authorized Service Centers Limited Warranty 0401MWMMDWJEM