JVC SR-DVM70US Connecting To A Dolby Digital Decoder, Or An Amplifier With Built-inDTS, NOTES:, CAUTIONS:

		SYSTEM CONNECTIONS EN 69
Connecting To A Dolby Digital Decoder		1 Connect the unit and a Dolby Digital Decoder or an amplifier
		with built-in DTS using either an optional optical cable or an
Or An Amplifier With Built-in DTS		optional coaxial cable.
		NOTES:
These instructions enable you to connect your unit to a Dolby		● For Dolby Digital sound, set ADIGITAL AUDIO OUTB to ADOLBY
		DIGITAL/PCMB. (A pg. 70)
Digital Decoder or an amplifier with built-in DTS.
		● For DTS sound, set ADIGITAL AUDIO OUTB to ASTREAM/PCMB.
		(A pg. 70)
		CAUTIONS:
		● This unit has a dynamic range of more than 110 dB with regards
		to its Hi-Fi audio capability. It is recommended that you check the
		maximum level if you are going to listen to the Hi-Fi audio signals
		through a stereo amplifier. A sudden surge in the input level to
		the speakers may damage them.
		● Some speakers and televisions are specially shielded to prevent
		television interference. If both are of the non-shielded type, do
Dolby Digital Decoder or		not place the speakers adjacent to the TV set as this can
		adversely affect the playback picture.
amplifier with built-in DTS
	To DIGITAL AUDIO
	input
Coaxial cable	Optical cable
(not supplied)	(not supplied)
To [DIGITAL	To [DIGITAL AUDIO
AUDIO OUT	OUT (OPTICAL)]
(COAXIAL)]

Rear of unit

Note for connection:

Remove the protection cap from the optical cable.