8
tINPUT LEVEL control
yCassette operation buttons (deck B)
|
| : Press to wind the tape quickly from right |
|
| to left. |
|
| : Press to wind the tape quickly from left to |
|
| right. |
| (stop) | : Press to stop the tape. |
| ||
|
| Also press to stop both decks simulta- |
|
| neously during dubbing. |
PLAY | : Press to start playback/recording. | |
| REC/ | : Press the PLAY button while pressing |
REC MUTE | this button to start recording, and press | |
|
| to leave an appropriate |
|
| section. (See page 9.) |
| PAUSE | : Press to stop the tape temporarily during |
| ||
|
| recording and playback. |
|
| Press the PLAY button to release the |
|
| pause mode. |
| (direction) | : Press to change the direction of tape |
| ||
|
| travel. |
uA B SYNCHRO DUBBING buttons Press to dub from deck A to deck B.
·NORM SPEED : Press to perform
· HIGH SPEED : Press to perform
AUTO REVERSE OPERATION
The auto reverse operation of this unit turns the tape transport over to the reverse of forward direction automatically when the tape reaches its end during recording or playback.
·Because of cassette shell construction, a tape recorded in the forward direction should be played back in the same direction to obtain stable sound reproduction.
·During recording, auto reverse can be activated only from the forward to the reverse direction. For good sound quality and to avoid accidental erasure of previously recorded material, always start recording with the side A of the tape facing out.
PLAYBACK
1 | POWER |
POWER |
|
ON OFF | STANDBY / ON |
| |
(B version) | (J version) |
2 |
|
| A |
3 | 4 | DOLBY B NR |
|
| B OFF C |
5 | REVERSE MODE | 6 |
|
|
PLAY
Playback of deck A
Operate in the order of the numbers in the illustration.
1Turn the power on.
2Load a prerecorded cassette with side A facing out.
3 Select the side to be played back.
Side A... Forward direction (PLAY )
Side B... Reverse direction ( PLAY)
4 Set the DOLBY NR switch to the same setting as when the
tape was recorded.
5 Select the REVERSE MODE switch as desired.
6 Press the PLAY button of deck A to start playback.
· When the deck contains a tape, it can be played back by just pressing the PLAY button in the B version only when the POWER switch is set to ON and the switch is at STANDBY. In the J version, the tape can be played back by pressing the PLAY button only when the POWER switch is set to STANDBY.
Playback of deck B
Perform steps 2 to 6 of the above procedure for deck B.
Continuous play
First set the REVERSE MODE switch to .
Load cassette tapes in both decks and press the PLAY button of the deck to be played first for continuous play of both decks.
·At this time, the CONT indicator lights in the multimode display. When the tape in the deck which plays first reaches the end of side B (in the reverse direction), it automatically switches to the forward direction and enters the standby mode. At the same time, the other deck starts playback. These operations con- tinue between decks A and B.
·While one deck is playing back, the cassette in the other one can be replaced. This is convenient for
Note:
·Use tapes recorded using the same NR mode in decks A and B.
± 7 ±