4Activate Surround or DSP Mode
You can enjoy three kinds of
Digital Multichannel
You can enjoy Dolby Digital or DTS Digital Surround when you playback Multichannel source on the external equipment.
To activate Dolby Digital or DTS Digital Surround
When playback source is encoded with Dolby Digital or DTS Digital Surround, the system detects it and activate Multichannel Surround automatically.
–For
Dolby Pro Logic
To activate Pro Logic II modes
Press SURROUND. | SURROUND |
The current Pro Logic II mode appears on the display for a while.
•Each time you press the button, Pro Logic II mode changes as follows:
PL II MUSIC 
PL II MOVIE
PL II OFF
• When Dolby Pro Logic II mode is activated, the | PRO LOGIC |
II indicator lights up on the display.
–For
DSP
THEATER, LIVE HOUSE
To activate DSP modes
Press DSP. | DSP |
The current DSP mode appears on the display for a | |
while. |
|
•Each time you press the button, DSP mode changes as follows:
LIVE HOUSE 
HALL 
CONCERT
DSP OFF 
THEATER 
STADIUM 
–For
Listening with the Headphones
You can enjoy the sound with headphones.
Connect a pair of headphones to the PHONES jack on the front panel. The speakers are diactivated and you can listen the sound with the headphones.
•Disconnecting a pair of headphones from the PHONES jack activate speakers.
CAUTION:
Be sure to turn down the volume:
•Before connecting or putting on headphones, as high volume can damage both the headphones and hearing.
•Before removing headphones, as high volume may output from the speakers.
Adjusting the Brightness
You can dim the indications on the display window and the illumination lamps on the center unit.
There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 1 again.
From the remote control ONLY:
1 Press DIMMER repeatedly until | DIMMER |
| |
“DIMMER (with the current setting) ” | SLEEP |
appears on the display. |
|
•Each time you press the button, the indication in the main display changes as follows:
DIMMER*
SLEEP**
*With the current level is shown.
**With the remaining time is shown.
2Press cursor 3/2 to adjust the
brightness level. | ENTER |
• The brightness level changes as follows:
DIMMER MIN (Minimum)
DIMMER MID (Middle)
DIMMER MAX (Maximum)
3 Press ENTER.
“OK” appears on the display and the
Notes:
•On some source signals, no sounds come out from the subwoofer.
•Before activating the Surround or DSP mode, adjust the speaker setting to bring out the best performance from this system.
For
brightness level changes.
ENTER
17
