Getting started

Connecting the AM (MW) and FM antennas

Make sure the antenna conductors do not touch any other terminals, connecting cords or power cords. Keep the AM loop antenna cable wrapped around the AM loop antenna frame, otherwise the effectiveness and sensitivity of the AM loop antenna may be reduced.

Connecting a TV

Connect the TV to the appropriate video out jacks to view the playback picture.Make the following settings after connecting the TV:–Scanning mode ( 12)–Monitor out ( 13)–MONITOR TYPE ( 23)

Connection using the HDMI terminal

From HDMI input

TV terminal

AM (MW) loop antenna (supplied)

FM antenna

(supplied)

Extend it horizontally.

Turn it until the best reception is obtained.

HDMI cable (not supplied)

You can make the following settings for the TV when the HDMI connection is used:

–HDMI DVI COLOR ( 23)–HDMI OUT ( 23)–HDMI AUDIO OUT ( 24)–DOWN MIX ( 24)*Use a certified HDMI cable, which has the HDMI logo.
For better FM reception

 

FM outdoor antenna

 

(not supplied)

Standard type (75 Ω

 

coaxial) connector (IEC

FM outdoor antenna cord

or DIN 45325)

(not supplied)

You can use a monitor with a DVI terminal by connecting with a DVI-HDMI conversion cable.

When you play HDCP (High-Bandwidth Digital Content Protection) source, allow a few seconds for the sound and picture to be transmitted to the speakers and TV while the confirmation process is completed.

On some TVs, no sound may come out during playback of sources such as DVD Audio even when

the HDMI AUDIO OUT setting is “ON” ( 24).

*This setting is available only when the speaker position

mode is set to “S.SPK F” ( 11).

7