PREPARATION
INSTALLING THE INPUT CARD
1.Turn off the Color Video Monitor’s main power and unplug the power cable from the AC outlet.
2.Unscrew the screws and remove the slot cover from the slot (on the rear side of the monitor) in which you are going to install the card.
| Rear side of the |
| color video monitor |
| Slot cover |
No. | 3. Insert the Input Card’s board |
| |
51961 | the guide rails on the top and bottom of the slot. |
Fit the board to | |
| the guide rails. |
| Knob |
| Guide rails |
Input card (the illustration shown is of the
Knob
4.Push the Input Card in so that its front panel touches the monitor’s rear panel.
5.Secure the Input Card by replacing the screws removed in Procedure 2.
NOTE : Do not touch the terminal connected to the monitor or board pattern.
Do not remove slot covers from the monitor’s slots if they are not in use.
8 | |
|
ATTACHING THE POWER CORD HOLDER
The provided Power Cord Holder prevents the AC power cord from being accidentally disconnected from the AC inlet.
The Power Cord Holder consists of two parts; a case and cover.
1.Attach the Power Cord Holder case to the AC inlet on the back of the monitor with 2 screws (provided).
Caution:
Use only the provided screws.
2. Attach the Power Cord Holder cover to the AC power cord.
Press the cover until it clicks.
3.Connect the AC power cord to the AC inlet, and join the Power Cord Holder cover with the case.
|
| Hold until it clicks. |
|
|
|
Caution: |
| Note: |
A different plug shape will result in the cover being |
| To disconnect the power cord, click the tab to open the |
attached to a different position. Check to make sure the |
| cover. |
plug doesn't pull out after the cover is attached. |
|
|
|
|
|
|
|
|
ENGLISH
| TM- |
9 | H1950CG |
|
