■4. Press the UP, DOWN, >, or < button to select the preset number.
UP button: | Increases the preset number by 1. |
DOWN button: | Decreases the preset number by 1. |
>button: Increases the preset number by ten. < button: Decreases the preset number by ten.
■5. Press the SET button.
After 1 second, the display returns to the broadcast frequency display.
■6. Repeat above steps 1 to 5 for each station you want to store in memory with a preset number.
To cancel during presetting, press the CANCEL button in
step 3 or 4.
To change the preset stations, repeat the same steps as
above.
Auto Presetting
In each band, you can automatically preset
| AUTO |
TUNER | PRESET |
|
BAND | (for 2 seconds) |
|
■1. Select a band by pressing the TUNER
BAND button.
■2. Press the AUTO PRESET button on the
Remote Control for more than two sec- onds.
■3. Repeat steps 1-2 for the other band.
■If you want to change the preset stations, carry out the Manual Presetting for the desired preset numbers.
CAUTION: If the System is unplugged or if a pow- er failure occurs, the preset stations will be erased after about 24 hours. If this happens, you will need to preset the stations again.
To Change the FM
Reception Mode
When you are tuned into an FM stereo broadcast, the “ST (Stereo)” indicator lights up and you can hear stereo effects.
If an FM stereo broadcast is hard to receive or noisy, you can select Monaural mode. Reception improves, but you lose any stereo ef- fect.
Press the FM MODE button on the Remote Control so that the “MONO” indicator lights up on the display.
| FM MODE |
ST(Stereo) | MONO |
To restore the stereo effect, press the FM MODE button on the
Remote Control so that the “MONO” indicator goes off.
English |
9