⁄To connect the powered subwoofer

From the powered subwoofer (not supplied)

The connected subwoofer can reproduce the bass sounds recorded in front left and right channels, but cannot reproduce the LFE signals encoded in multi-channel software.

•Before plugging the System to the power supply, make sure that the powered subwoofer is turned off.

@TV/monitor

Connect the COMPONENT jacks, S-VIDEO jack, or VIDEO jack; whichever you want to use.

•You can get better picture quality in the order of— Composite video ]S-Video ]Component video.

Green

Red

Component video cord

 

(not supplied)

 

Blue

•This connection allows you to use the progressive scanning mode. To select progressive (PROGRESS) scanning mode (see page 16), use VIDEO OUT (COMPONENT) jacks.

Composite video cord (supplied)

S-Video cord (not supplied)

•After connecting a TV, select the appropriate video signal output according to the connection method. See “Changing the Color System and Scanning Mode” on page 16.

When connecting a USB mass storage class device

On the front panel

USB cable (not supplied)

•When connecting with a USB cable, use the USB 2.0 cable whose length is less than 1 m.

•You can connect a USB mass storage class device such as a USB flash memory device, hard disk drive, multimedia card reader, etc. to this System.

•You cannot connect a computer to the USB memory

terminal () of the System.

•You cannot connect JVC Everio camcorder to the USB

memory terminal () of the System.

•Noise and static electricity may stop the USB mass storage class device sound. In this case, disconnect and connect the USB mass storage class device again after turning off the System.

When connecting a digital audio player

On the front panel

Stereo mini plug (not supplied)

From audio output (or headphone out, etc.)

Preparing the remote control

Insert the battery into the remote control by matching the polarity ( + and –) correctly.

If the range or effectiveness of the remote control decreases, replace both batteries.

Caution

Battery shall not be exposed to excessive heat such as sunshine, fire, or the like.

When using the remote control

Point the top of the remote control towards the remote sensor as directly as possible. If you operate it from a diagonal position, the operating range (approx. 5 m) may be shorter.

6