Side
JK
MONITOR OUT | PAL OFF NTSC | RESET |
STATUS
IRIS
M L
J[MONITOR OUT] Monitor Output Selection Switch
Use this switch to select the availability of output from the N [MONITOR OUT] terminal as well as the signal system.(A Page 12)
NTSC : Outputs NTSC signals.
OFF | : No output. Select this value when |
| distributing images to the network. |
PAL | : Outputs PAL signals. |
[Default setting: OFF]
Note:
●Images are not distributed to the network when ANTSCB or APALB is selected.
●When the switch is changed, press the K [RESET] button for less than 2 seconds to restart.
K [RESET] Reset Button
This button functions in two different ways depending on how it is pressed.
●Reset function
Press and release the button for less than two seconds to restart
●Focus Assist function
Press and hold down for at least two seconds but less than five seconds.
The L [STATUS] indicator starts blinking in green color and orange color repeatedly, and
the Focus Assist mode is enabled. (A Page 24)
You can also perform the same operation on the viewer.(A Page 93)
Memo:
Pressing and holding the button for five seconds or longer enables the service confirmation mode. The L [STATUS] indicator lights up in orange color in this mode. Do not press the button for 5 seconds or longer.
L [IRIS] Iris Terminal
Use this terminal to connect the DC iris lens. (Connection with the video iris lens is not possible.)
M [STATUS] Status Indicator
This status of this product is indicated in green or orange color.
Starting up: Lights up in orange
Startup complete: Lights up in green
Error: Blinks in orange
Memo:
●The indicator alternates lighting up in green color and orange color repeatedly when in the Focus Assist mode. (A Page 24)
●Blinks in green color after reboot when
“Identify Unit”is set to“Blink”(A Page 75).
●You can turn off the indicator after startup is complete using the [LED State] of
11