JVC XL-MC222BK manual Precautions, Setting UP

PRECAUTIONS

Installation

•Select the best location

Select a level location to install this component, where it is free from extremes of temperature (5 to 35°C, or 41 to 95°F) and humidity, dust, or vibration.

If noise interference is caused in receiving AM broadcast by a tuner/receiver located nearby, relocate it or this component, or turn off either one.

•Moving the unit

Before moving the unit, first remove all the discs. Turn the power off, making sure the standby indicator is on. Then remove the AC power cord from the AC outlet.

Compact discs

• Use only compact digital audio discs

Only the audio compact discs identified by	'
the logo shown below can be used with this
component.

Operation

•Keep the disc storage free of obstacles

Do not put anything other than discs in slots of the disc storage.

•Turn the power off if a problem occurs

If an unusual condition arises, turn the power off immediately. If the condition persists whenever the power is turned on, consult your JVC dealer.

•Do not pull the AC cord

Do not pull the cable when unplugging the AC cord from the wall socket or this component — hold and pull the plug body.

•Set the sound volume carefully

Be careful in setting the sound volume on your amplifier/receiver when playing a CD, which has almost none of background noise unlike analog records and tapes. Find out the right setting starting with a low level setting. Setting the level too high and starting a CD could damage the speakers.

•Protect the component against condensation

Condensation on the component could disrupt the proper transmission of the disc-reading laser beam, causing noise or malfunction. If condensation ever ensues due to excessive humidity or sudden temperature change, leave the component turned on for a couple of hours to dry up — consult your JVC dealer if this does not correct the condition.

SETTING UP

Connecting the unit

This compact disc changer/player needs to be connected to an amplifier/receiver for audio reproduction.

CAUTION

Do not connect the AC power cord until all other neces- sary connections have been made.

1.First connect the OUTPUT ports in the back of this unit with the CD or AUX input ports of the amplifier/receiver using the accessory audio cord. Be sure to insert the audio cord jacks firmly into the proper ports matching the output and input channels — RIGHT to RIGHT and LEFT to LEFT.

Audio cord

	OUTPUT	COMPULINK-3
(White)	LEFT	(SYNCHRO)
(Red)	RIGHT

To input audio jack of the amplifier/receiver

2.If you are connecting the unit to a JVC audio component and using the CompuLink-3 remote control system, connect the units with the accessory CompuLink cord. Either one of the COMPULINK-3 (SYNCHRO) ports in the back of this unit can be used.

OUTPUT	COMPULINK-3	CompuLink cord
	(SYNCHRO)

LEFT

RIGHT

To CompuLink jack

When you use the system, you can remote-control this CD unit from the connected JVC amplifier/receiver. (See Page 11 for more information.)

NOTE: JVC components equipped with two COMPULINK-3 (SYNCHRO) ports can be connected in series; a com- ponent with only one port may be connected at the end of the series.

2